Related Experiment Video
Updated: Jul 12, 2026

Real-time Electrophysiology: Using Closed-loop Protocols to Probe Neuronal Dynamics and Beyond
Published on: June 24, 2015
Afterhyperpolarization-firing rate relation of turtle spinal neurons
E K Stauffer1, D G Stuart, J C McDonagh
1Department of Physiology, University of Minnesota, Duluth, MN 55812-2487, USA.
Abstract:
This study addressed the afterhyperploarization-firing rate relationship of unanesthetized turtle spinal motoneurons and interneurons. The afterhyperploarization of their solitary action potential at rheobase was compared to that during the cells' minimum and maximum firing rates. Like previous mammalian findings, afterhyperpolarization duration and area at rheobase were 32 and 19% less for high- versus low-threshold motoneurons. Contrariwise, maximum firing rate was two times less for the high-threshold group. Other new findings were that for high- versus low-threshold interneurons, afterhyperpolarization duration and area were 25 and 95% less, and maximum firing rate 21% higher for the high-threshold group. For combined motoneurons versus interneurons, there were no differences in afterhyperpolarization duration and area at rheobase, whereas maximum firing rate was 265% higher for the interneurons. For high-threshold motoneurons alone, there were significant associations between minimum firing rate and afterhyperpolarization duration and area measured at rheobase. In summary, this study showed that (1) the afterhyperploarization values of both turtle spinal motoneurons and interneurons at rheobase provided little indication of their corresponding values at the cells' minimum and maximum firing states, and (2) the evolution of afterhyperploarization from rheobase to maximum firing state differed both qualitatively and quantitatively for motoneurons versus interneurons.
More Related Videos
11:07In Vivo Intracellular Recording of Type-Identified Rat Spinal Motoneurons During Trans-Spinal Direct Current Stimulation
Published on: May 11, 2020
06:55The Ex vivo Preparation of Spinal Cord Slice for the Whole-Cell Patch-Clamp Recording in Motor Neurons During Spinal Cord Stimulation
Published on: September 8, 2023
Related Concept Videos
Action Potentials
Action Potential
Membrane potential in neurons
Neurons typically have a resting membrane potential of about -70 millivolts (mV). When they receive...
The Role of Ion Channels in Neuronal Computation
Sometimes a single EPSP is strong enough to induce an action potential in the postsynaptic neuron. However, multiple presynaptic inputs must often create EPSPs around the same time for the postsynaptic neuron to be sufficiently depolarized to fire an action potential.
Action Potential
Membrane potential in neurons
Neurons typically have a resting membrane potential of about -70 millivolts (mV). When they receive...
Action Potential: Phases of Stimulation
Resting Phase:
In this phase, the cell's membrane is at its resting potential, typically around -70 millivolts (mV) for neurons. Inside the cell, there is a higher concentration of potassium ions (K+) and a lower concentration of sodium ions (Na+). Voltage-gated sodium channels are closed, and...
Propagation of Action Potentials
Neurons (nerve cells) have a resting membrane potential, with a slightly negative charge inside compared to outside. This is maintained by ion channels, such as sodium (Na+) and potassium (K+) channels, which control the flow of ions. When a stimulus, like a touch or a signal from another neuron, triggers the neuron, sodium channels open, allowing sodium ions to...