The esophageal-tracheal combitube resistance and ventilatory pressures
Luis A Gaitini1, Sonia J Vaida, Somri Mostafa
1Department of Anesthesiology, B'nai Zion Medical Center, Haifa 31048, Israel. l.gaitini@b-zion.org.il
Study Objective:
To measure resistance of the Combitube, a supraglottic ventilatory device used in the management of the patients with difficult airways, and its influence on delivered ventilatory pressures.
Design:
Prospective study.
Setting:
University-affiliated hospital.
Patients:
A total of 20 patients with ASA status I or II who were scheduled for elective knee arthroscopy.
Interventions:
(Part 2 of the study) After induction of general anesthesia and insertion of the Combitube, mechanical ventilation was initiated. Airway pressures were measured using fluid-filled pressure lines at the Y-piece (P(Y-piece)) of the breathing system and in the oropharynx (P(oropharynx)) at a position 2 cm beyond the second proximal anterior hole of the Combitube. These pressures were simultaneously recorded and the pressure curves were compared.
Measurements:
(Part 1 of the study) Resistance of the esophageal and the tracheal lumen of the 37-F Combitube and standard endotracheal tubes (with internal diameters of 6, 7, and 8 mm) was compared ex vivo with a Datex AS/3 monitor. Ventilation conditions were kept constant at a tidal volume of 0.5 L, frequency of 10 breaths per minute, and ramp flow waveform and peak flow of 1 L/s.
Main Results:
Resistance of standard endotracheal tubes was inversely proportional to their diameters (16, 11, and 7 cm H(2)O/L per second for the tubes with internal diameters of 6, 7, and 8 mm, respectively). The resistance of the Combitube's tracheal lumen was 12 cm H(2)O/L per second. There was a significant difference in peak respiratory pressures between P(Y-piece) and P(oropharynx) (40 +/- 5 and 23 +/- 5 cm H(2)O, respectively).
Conclusions:
The Combitube has significant airflow resistance that should be considered when patients are mechanically ventilated because the delivered oropharyngeal pressure is significantly lower than the pressure measured at the anesthesia breathing system.
Related Concept Videos
01:22Trachea
Anatomical Features:
Location: About half of the trachea is situated in the neck, anterior to the esophagus, and extends from the larynx (at the level of the...
01:24Pressure Relationships in Thoracic Cavity
Breathing Mechanisms
Both intra-alveolar and intrapleural pressures rely on specific lung properties. The ability to breathe—allowing air to enter the lungs during...
01:19Factors Affecting Pulmonary Ventilation
Alveolar Surface Tension
The alveolar fluid lines the luminal surface of the alveoli and exerts a force called surface tension. This force is caused by the polar water molecules in the liquid being more strongly attracted to each...
01:16Oxygen Delivering System II: Venturi Mask and Transtracheal Oxygen
Venturi Mask
The Venturi mask, named after the Venturi effect, is designed to deliver precise oxygen concentrations. It consists of a large tube with an oxygen inlet that narrows down, causing a pressure drop that pulls air in through adjustable side ports. The mask is a lightweight,...
01:15Endotracheal Intubation I: Procedure
The ET tube comprises various components, including a standard adaptor to attach a bag-valve-mask (BVM) or ventilator, a cuff, a pilot balloon, and radiopaque markings along its length to measure the insertion distance. The tube sizes...
01:23Mechanical Ventilation II: Invasive Ventilation
Negative-Pressure Ventilators
Negative-pressure ventilators create a vacuum around the chest or body to draw air into the lungs, simulating breathing. This method does not require an...