Related Experiment Video
Updated: Aug 15, 2026

Confocal Imaging of Confined Quiescent and Flowing Colloid-polymer Mixtures
Published on: May 21, 2014
Scaling of the kinetics of slow aggregation and gel formation for a fluorinated polymer colloid
Peter Sandkühler1, Jan Sefcik, Massimo Morbidelli
1Swiss Federal Institute of Technology Zurich, Institut für Chemie- und Bioingenieurwissenschaften, ETH-Hönggerberg/HCI, CH-8093 Zurich, Switzerland.
Abstract:
The aggregation and gelation kinetics in moderately concentrated (0.004 = phi(0) = 0.1) colloidal dispersions of fluorinated polymer particles has been studied. The aggregation was adjusted to proceed slowly enough to allow a convenient characterization of the kinetics through static and dynamic light scattering on quenched and diluted samples. A population balance model based on second-order aggregation rates is developed to compute the time evolution of the cluster mass distribution, from which we calculate the values of the average radii and structure factor measured by light scattering, so as to allow a direct comparison between measured and calculated quantities. The model suggests the introduction of a dimensionless time which allows the scaling of all the aggregation data on unique master curves defined by only two parameters: the exponent of the power-law aggregation kernel, lambda, and the aggregate fractal dimension, d(f). The predicted master curves were observed experimentally, which confirms the validity of the aggregation model and allows the unique determination of the kinetic and structural parameters of the aggregation process. The cluster growth behavior, although significantly slower than DLCA, shows power-law kinetics rather than the exponential one typical of RLCA and the cluster structure is characterized by an unexpectedly small fractal dimension, d(f) = 1.7. The occurrence of gelation has been characterized using small amplitude oscillatory shearing to monitor the time evolution of the elastic modulus. It is found that also these curves, together with the gel time value, scale with the stability ratio of primary particles for a given solid volume fraction. We further use the model to calculate the cumulative occupied volume fraction of the growing aggregates and quantify in this way the increasing space filling, which is solid volume fraction dependent. The experimentally determined dimensionless gel times, which are also solid volume fraction dependent, scale then directly with the dimensionless time to reach a certain degree of the space filling in the model. This finding suggests that, like the aggregation kinetics, the gelation kinetics is governed by a second-order rate process.
More Related Videos
11:34Controlled Synthesis and Fluorescence Tracking of Highly Uniform Poly(N-isopropylacrylamide) Microgels
Published on: September 8, 2016
12:07Fabricating Degradable Thermoresponsive Hydrogels on Multiple Length Scales via Reactive Extrusion, Microfluidics, Self-assembly, and Electrospinning
Published on: April 16, 2018
Related Concept Videos
Colloidal precipitates
The Colloidal State