Related Experiment Video
Updated: Aug 18, 2026

The Effect of Interfacial Chemical Bonding in TiO2-SiO2 Composites on Their Photocatalytic NOx Abatement Performance
Published on: July 4, 2017
Acetone and water on TiO2(110): H/D exchange
1Interfacial Chemistry and Engineering Group, Pacific Northwest National Laboratory, P.O. Box 999, MS K8-93, Richland, Washington 99352, USA. ma.henderson@pnl.gov
Abstract:
Isotopic H/D exchange between coadsorbed acetone and water on the TiO2(110) surface was examined using temperature programmed desorption (TPD) as a function of coverage and two surface pretreatments (O2 oxidation and mild vacuum reduction). Coadsorbed acetone and water interact repulsively on reduced TiO2(110) on the basis of results from the companion paper to this study, with water exerting a greater influence in destabilizing acetone and acetone having only a nominal influence on water. Despite the repulsive interaction between these coadsorbates, about 0.02 monolayers (ML) of a 1 ML d6-acetone on the reduced surface (vacuum annealed at 850 K to a surface oxygen vacancy population of 7%) exhibits H/D exchange with coadsorbed water, with the exchange occurring exclusively in the high-temperature region of the d6-acetone TPD spectrum at approximately 340 K. The effect was confirmed with combinations of d0-acetone and D2O. The extent of exchange decreased on the reduced surface for water coverages above approximately 0.3 ML due to the ability of water to displace coadsorbed acetone from first layer sites to the multilayer. In contrast, the extent of exchange increased by a factor of 3 when surface oxygen vacancies were pre-oxidized with O2 prior to coadsorption. In this case, there was no evidence for the negative influence of high water coverages on the extent of H/D exchange. Comparison of the TPD spectra from the exchange products (either d1- or d5-acetone depending on the coadsorption pairing) suggests that, in addition to the 340 K exchange process seen on the reduced surface, a second exchange process was observed on the oxidized surface at approximately 390 K. In both cases (oxidized and reduced), desorption of the H/D exchange products appeared to be reaction limited and to involve the influence of OH/OD groups (or water formed during recombinative desorption of OH/OD groups) instead of molecularly adsorbed water. The 340 K exchange process is assigned to reaction at step sites, and the 390 K exchange process is attributed to the influence of oxygen adatoms deposited during surface oxidation. The H/D exchange mechanism likely involves an enolate or propenol surface intermediate formed transiently during the desorption of oxygen-stabilized acetone molecules.
Related Concept Videos
Oxidation of Alkenes: Syn Dihydroxylation with Osmium Tetraoxide
Aldehydes and Ketones with Water: Hydrate Formation
The formation of hydrates is a reversible reaction. Hydrate formation is influenced by steric and electronic factors accompanying the alkyl substituents on the carbonyl group: The rate of hydrate formation increases with a decrease in the number of alkyl groups attached to the carbonyl carbon. Hence,...
Oxidation of Alkenes: Anti Dihydroxylation with Peroxy Acids
Alkenes via Reductive Coupling of Aldehydes or Ketones: McMurry Reaction
Acid-Catalyzed Hydration of Alkenes
Alkynes to Aldehydes and Ketones: Acid-Catalyzed Hydration
Analogous to alkenes, alkynes also undergo acid-catalyzed hydration. While the addition of water to an alkene gives an alcohol, hydration of alkynes produces different products such as aldehydes and ketones.

