Evaluation of the Hennessy grading probe to predict yields of lamb carcasses fabricated to multiple end points

Lamb carcasses (n = 278) were selected immediately after slaughter and fat thickness was measured with the SP2 Hennessy grading probe (HP) at the interface of the 12th and 13th ribs, 3.8 cm from the backbone. After a 24-h chilling period, carcasses were graded by a USDA grader and probed with the HP to obtain a fat thickness measure on the chilled carcass. One hundred sixty-five carcasses were fabricated into wholesale cuts (.64 cm of external fat trim), and 113 carcasses were fabricated into tray-ready retail cuts (.25 cm of external fat trim). Carcass weight, fat thickness (metal probe), adjusted fat thickness, hot and chilled carcass HP fat measures, as well as kidney and pelvic fat percentage and USDA yield grade, were highly correlated to cutting yield for both fabrication methods. Regression models developed to predict wholesale cut yields using HP or grader-collected measures were similar with respect to predictive accuracy. Fat thickness explained most of the variation in wholesale and tray-ready cut yields among the variables collected by the grader. Kidney and pelvic fat accounted for more of the variation in yield of wholesale cuts during stepwise regression to determine HP equations, but for predicting tray-ready yields, fat thickness taken with the HP accounted for the largest amount of variation. Equations developed to predict tray-ready retail cut yields using the HP or USDA grader-collected carcass measures were similar in the amount of variation explained. Kidney and pelvic fat percentage must be included in equations to maximize predictive accuracy when this depot site is left in carcasses.