Surface chemistry studies of (CdSe)ZnS quantum dots at the air-water interface

Trioctylphosphine oxide- (TOPO-) capped (CdSe)ZnS quantum dots (QDs) were prepared through a stepwise synthesis. The surface chemistry behavior of the QDs at the air-water interface was carefully examined by various physical measurements. The surface pressure-area isotherm of the Langmuir film of the QDs gave an average diameter of 4.4 nm, which matched very well with the value determined by transmission electron microscopy (TEM) measurements if the thickness of the TOPO cap was counted. The stability of the Langmuir film of the QDs was tested by two different methods, compression/decompression cycling and kinetic measurements, both of which indicated that TOPO-capped (CdSe)ZnS QDs can form stable Langmuir films at the air-water interface. Epifluorescence microscopy revealed the two-dimensional aggregation of the QDs in Langmuir films during the early stage of the compression process. However, at high surface pressures, the Langmuir film of QDs was more homogeneous and was capable of being deposited on a hydrophobic quartz slide by the Langmuir-Blodgett (LB) film technique. Photoluminescence (PL) spectroscopy was utilized to characterize the LB films. The PL intensity of the LB film of QDs at the first emission maximum was found to increase linearly with increasing number of layers deposited onto the hydrophobic quartz slide, which implied a homogeneous deposition of the Langmuir film of QDs at surface pressures greater than 20 mN.m(-1).