Related Experiment Video
Updated: Aug 17, 2026

A Friction Testing-Bioreactor Device for Study of Synovial Joint Biomechanics, Mechanobiology, and Physical Regulation
Published on: June 2, 2022
Effect of dynamic loading on the frictional response of bovine articular cartilage
Ramaswamy Krishnan1, Elise N Mariner, Gerard A Ateshian
1Department of Mechanical Engineering, Columbia University, 500 West 120th Street, 220 S.W. Mudd Mail Code 4703, New York, NY 10027, USA.
Abstract:
The objective of this study was to test the hypotheses that (1) the steady-state friction coefficient of articular cartilage is significantly smaller under cyclical compressive loading than the equilibrium friction coefficient under static loading, and decreases as a function of loading frequency; (2) the steady-state cartilage interstitial fluid load support remains significantly greater than zero under cyclical compressive loading and increases as a function of loading frequency. Unconfined compression tests with sliding of bovine shoulder cartilage against glass in saline were carried out on fresh cylindrical plugs (n=12), under three sinusoidal loading frequencies (0.05, 0.5 and 1 Hz) and under static loading; the time-dependent friction coefficient mu(eff) was measured. The interstitial fluid load support was also predicted theoretically. Under static loading mu(eff) increased from a minimum value (mu(min)=0.005+/-0.003) to an equilibrium value (mu(eq)=0.153+/-0.032). In cyclical compressive loading tests mu(eff) similarly rose from a minimum value (mu(min)=0.004+/-0.002, 0.003+/-0.001 and 0.003+/-0.001 at 0.05, 0.5 and 1 Hz) and reached a steady-state response oscillating between a lower-bound (mu(lb)=0.092+/-0.016, 0.083+/-0.019 and 0.084+/-0.020) and upper bound (mu(ub)=0.382+/-0.057, 0.358+/-0.059, and 0.298+/-0.061). For all frequencies it was found that mu(ub)>mu(eq) and mu(lb)
More Related Videos
Related Concept Videos
Characteristics of Dry Friction
Before the wheelbarrow starts moving, the static frictional force acts tangentially to the contact surface, opposing the force that is about to induce the motion. This frictional force prevents the...
Static and Kinetic Frictional Force
However, if two systems are in contact and are stationary relative to one...
Dry Friction
To illustrate this concept, imagine a wooden crate resting on a rough, non-uniform horizontal surface. When an external force is applied to...
Normal Strain under Axial Loading
Static Friction
For example, consider a scenario where a truck is connected to a car by a rope, ready to tow it along a road. When no external force is applied by the truck, the car remains stationary and is said to be in static equilibrium. In this case, the forces acting on the car, such as gravity and the...

