An in situ FTIR-ATR study of polyacrylate adsorbed onto hematite at high pH and high ionic strength

FTIR-ATR was used to examine in situ the interaction of polyacrylate and hematite at pH 13. Static light scattering and mobility measurements were used to assess solution polyacrylate dimensions and hematite surface charge, respectively. Polyacrylate adsorption occurred only with the addition of electrolyte (e.g., NaCl), and it was found that excess cations, up to approximately 1 M, facilitated adsorption, above which the effect was found to plateau. At pH 13 and at low ionic strength, adsorption of polyacrylate onto hematite is facilitated by cations in solution shielding both the negative acrylate functionality of the polymer and the negative hematite surface. The shielding of the hematite surface continues to increase with increasing salt concentration up to a measured 3 M. Similarly, the shielding of the polymer increased with electrolyte concentration up to approximately 1 M salt, beyond which no further increase in shielding was observed. At this concentration the polymer assumes a finite minimum size in solution that ultimately limits the amount adsorbed. The dimension of the polymer in solution was found to be independent of monovalent cation type. Thus, at high pH and high ionic strength adsorption is determined by the degree of hematite surface charge reduction. The cation-hematite surface interaction was found to be specific, with lithium leading to greater polyacrylate adsorption than sodium, which was followed by cesium. The stronger affinity of lithium for the hematite surface over sodium and cesium is indicative of the inverse lyotropic adsorption series and has been rationalized in the past by the "structure-making-structure-breaking" model. These results provide a useful insight into the likely adsorption mechanism for polyacrylate flocculants at high pH and ionic strength onto residues in the Bayer processing of bauxite.