Arterial laser welding with a 1.9 micrometer Raman-shifted laser

A new 1.9 micron Raman-shifted neodymium:yttrium aluminum garnet (Nd:YAG) laser was used for small vessel welding. Bursting pressures and stresses of sutured and laser-welded arteriotomies created in the rat femoral artery and aorta were measured. Sutured arteriotomies had a significantly higher burst stress than laser-welded arteriotomies. Although there were no significant differences in burst stress at the various laser powers tested, an optimal power was identified. The laser was also used to weld transected rat aortas. The average power delivered was 200 mW for 30 seconds per anastomosis. The average time for completing an anastomosis was 6 minutes compared with 18 minutes when sutures were used. In relation to proximal aortic diameter, there was a 7.9% decrease at the anastomosis immediately (n = 4), and a 6.6% and 4.9% increase occurred at 24 hours (n = 4) and 10 weeks (n = 5), respectively. Acute anastomotic compliance, and compliance at 24 hours and 10 weeks were decreased by 47.2%, 39.5%, and 47.8%, respectively, and were similar to sutured anastomoses. Histology showed little thermal denaturation of the aorta within 0.6 mm of the anastomosis, approximately 1 mm of medial cell death, and nearly normal elastic fiber alignment. One focal false aneurysm was noted at 10 weeks. Although the sutured and laser-welded anastomoses share similar compliance changes, the laser-welded anastomoses are more isodiametric. This preliminary experience with the 1.9 micron laser shows the distinct advantages of a handheld fiber, no requirement for cooling irrigation, speed, and no difference in compliance from sutured anastomoses.