Related Experiment Video
Updated: Aug 17, 2026

Fluorescence Recovery after Merging a Droplet to Measure the Two-dimensional Diffusion of a Phospholipid Monolayer
Published on: October 15, 2015
The collapse of monolayers containing pulmonary surfactant phospholipids is kinetically determined
Wenfei Yan1, Barbora Piknova, Stephen B Hall
1Department of Biochemistry and Molecular Biology, Oregon Health & Science University, Portland, Oregon 97239-7368, USA.
Abstract:
Prior studies have shown that during and after slow compressions of monomolecular films containing the complete set of purified phospholipids (PPL) from calf surfactant at an air/water interface, surface pressures (pi) reach and sustain values that are remarkably high relative to expectations from simple systems with model lipids. Microscopy shows that the liquid-expanded, tilted-condensed, and collapsed phases are present together in the PPL films between 45 and 65 mN/m. The Gibbs phase rule restricts equilibrium coexistence of three phases to a single pi for films with two components but not for more constituents. We therefore determined if the surprising stability of PPL reflects release from the thermodynamic restrictions of simple model systems by the presence of multiple components. Experiments with binary films containing dioleoyl phosphatidylcholine and dipalmitoyl phosphatidylcholine first tested the predictions of the phase rule. The onset of three-phase coexistence, determined by fluorescence microscopy, and its termination, established by relaxation of collapsing films on a captive bubble, occurred at similar pi. Experiments for PPL using the same methods suggested that the three phases might coexist over a range of pi, but limited to approximately 2 mN/m, and extending below rather than above the coexistence pi for the binary films. Our results show that the PPL films at high pi must deviate from equilibrium and that they must then be metastable.
Related Concept Videos
Micelles
Surface Active Agents
Asymmetric Lipid Bilayer
Theories of Dissolution: Diffusion Layer Model
This process starts with a thin layer, saturated with the drug, forming at the interface between the solid and liquid. The solute then diffuses from this layer into the main solution. The Noyes-Whitney equation suggests that the rate of dissolution relies on the diffusion...
Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model

