White's effect: removing the junctions but preserving the strength of the illusion

Piers D L Howe1

  • 1Harvard Medical School, 220 Longwood Avenue, WAB 232, Boston, MA 02115, USA. phowe@hms.harvard.edu

Perception
|July 5, 2005
PubMed

Related Concept Videos

Woodward–Hoffmann Selection Rules and Microscopic Reversibility01:34

Woodward–Hoffmann Selection Rules and Microscopic Reversibility

Electrocyclic reactions, cycloadditions, and sigmatropic rearrangements are concerted pericyclic reactions that proceed via a cyclic transition state. These reactions are stereospecific and regioselective. The stereochemistry of the products depends on the symmetry characteristics of the interacting orbitals and the reaction conditions. Accordingly, pericyclic reactions are classified as either symmetry-allowed or symmetry-forbidden. Woodward and Hoffmann presented the selection criteria for...
Anchoring Junctions01:03

Anchoring Junctions

Anchoring junctions are multiprotein complexes that help cells connect to other cells and the extracellular matrix. Anchoring junctions are present on the lateral and basal surfaces of cells, providing strong and flexible connections. Focal adhesions are often formed due to cell interactions with the ECM substrata, which initiate signal transduction via kinase cascades and other mechanisms. Together, they provide stability and tissue integrity. There are three types of anchoring junctions:...
Boundary Conditions: Lossless Lines01:21

Boundary Conditions: Lossless Lines

Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Effects of Creep01:25

Effects of Creep

Creep in concrete, the gradual deformation under prolonged stress, significantly impacts the integrity of structures. For reinforced concrete beams, it can be a vital design consideration, as it increases deflection, sometimes necessitating additional design measures. In columns, especially slender ones under eccentric loads, creep can cause buckling, compromising their stability. However, creep can be beneficial in indeterminate structures by mitigating stresses that arise from shrinkage,...
First Pass Effect01:12

First Pass Effect

Presystemic elimination, or the first-pass effect, is the metabolism of drugs that reduces their effective concentration at the site of action. Apart from the first-pass effect, the systemic bioavailability of the drug is also reduced by other factors, including incomplete absorption or chemical degradation of drugs.
Depending on the route of administration, drugs can be metabolized in the liver, intestine, lungs, and vasculature. Orally administered drugs are first absorbed through the...
Wheatstone Bridge01:29

Wheatstone Bridge

An ohmmeter is a resistance-measuring device. It works by applying a voltage to a resistor of unknown resistance and measuring the current across the resistor. The resistance value is deduced using Ohm's law. Usually, the standard configuration of an ohmmeter comprises a voltmeter or an ammeter. However, such configurations are limited in accuracy because the meters alter the voltage applied to the resistor and the current that flows through it.
Thus, for accurate resistance measurements, a...