Related Experiment Video
Updated: Aug 16, 2026

A Two-interval Forced-choice Task for Multisensory Comparisons
Published on: November 9, 2018
Temporal frequency characteristics of synchrony-asynchrony discrimination of audio-visual signals
Waka Fujisaki1, Shin'ya Nishida
1NTT Communication Science Laboratories, NTT Corporation, 3-1 Morinosato Wakamiya, Atsugi, Kanagawa, 243-0198, Japan.
Abstract:
Temporal synchrony is a critical condition for integrating information presented in different sensory modalities. To gain insight into the mechanism underlying synchrony perception of audio-visual signals we examined temporal limits for human participants to detect synchronous audio-visual stimuli. Specifically, we measured the percentage correctness of synchrony-asynchrony discrimination as a function of audio-visual lag while changing the temporal frequency and/or modulation waveforms. Audio-visual stimuli were a luminance-modulated Gaussian blob and amplitude-modulated white noise. The results indicated that synchrony-asynchrony discrimination became nearly impossible for periodic pulse trains at temporal frequencies higher than 4 Hz, even when the lag was large enough for discrimination with single pulses (Experiment 1). This temporal limitation cannot be ascribed to peripheral low-pass filters in either vision or audition (Experiment 2), which suggests that the temporal limit reflects a property of a more central mechanism located at or before cross-modal signal comparison. We also found that the functional behaviour of this central mechanism could not be approximated by a linear low-pass filter (Experiment 3). These results are consistent with a hypothesis that the perception of audio-visual synchrony is based on comparison of salient temporal features individuated from within-modal signal streams.
Related Concept Videos
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any finite,...
Properties of Fourier Transform II
The Frequency Shifting property of Fourier Transforms highlights that a shift in the frequency domain corresponds to a phase shift in the time domain. Mathematically, if x(t) has...
Classification of Signals
A continuous-time signal holds a value at every instant in time, representing information seamlessly. In contrast, a discrete-time signal holds values only at specific moments, often denoted as x(n), where...
Beats
Sampling Theorem

