The use of tracer gases to determine dust dispersion patterns and ventilation parameters in a mineral processing...

A study was conducted in a fluorspar milling plant to assess the effectiveness of tracer gases as a reliable supplement to conventional air-monitoring and ventilation measurements. In the course of this study, a tracer gas was used as a surrogate substance to analyze the direction and the rate of spread of contaminants from various potential dust production points in the plant. Time-weighted average and continuous mineral dust concentrations were measured in several areas of the plant; these results were compared and correlated with steady-state tracer gas concentrations in the mill. Time-weighted average dust concentrations varied between 0.18 and 0.57 mg/m3 for total dust and 0.04 and 0.20 mg/m3 for quartz respirable dust, depending on the location. Correlation of these values with steady-state tracer gas concentrations yielded linear relationships with correlation coefficients (R2) of 0.95 and 0.87, respectively, for total and quartz dust. Results from this study, therefore, indicate that tracer gases may help model the spread of airborne respirable dust from point sources. These tracer gas releases also allowed the simultaneous quantitative determination of air residence times and contaminant clearance times from the building. Hence, tracer gases will help industrial hygienists obtain useful data with respect to building ventilation.