Use of bentonite and activated carbon in controlled release formulations of carbofuran

Controlled release systems (CRS), unlike the conventional formulations, facilitate a gradual and controlled discharge of the pesticides, reducing the losses by evaporation and leaching and minimizing pesticide pollution. In this study, carbofuran-an insecticide-nematicide identified as a groundwater pollutant-was incorporated in alginate-based granules to obtain controlled release properties. The effect on carbofuran release rate caused by the incorporation of bentonite, activated carbon, and different mixtures of both sorbents in alginate basic formulation was studied by immersion of the granules in water. The water uptake, sorption capacity of the sorbent, permeability, and time taken for 50% of the active ingredient to be released into water, T(50), were calculated by the comparison of the preparations. T(50) values were higher for those formulations containing bentonite and/or activated carbon (T(50) values range from 14.76 h for the alginate formulation containing only bentonite as the sorbent to 29.5 weeks for the alginate formulation containing only activated carbon as the sorbent) than for the preparation without these sorbents (11.72 h). On the basis of a parameter of an empirical equation used to fit the insecticide-nematicide release data, it appears that the release of carbofuran from the various formulations into water is controlled by a diffusion mechanism. The sorption capacity of the sorbents for carbofuran was the most important factor modulating carbofuran release. In addition, it was observed that there is a linear correlation of the T(50) values and the content of activated carbon in dry granules.