Plasma treatment of polyurethane coating for improving endothelial cell growth and adhesion

The advantage of helium plasma treatment in enhancing endothelial cell growth and adhesion on polyurethane film coated on glass substrate is demonstrated with experimental data. Human coronary artery endothelial cell (HCAE) growth and attachment was studied on (1) bare glass substrate, used as control, (2) coated glass, with and without helium plasma treatment and (3) collagen-treated polyurethane-coated glass substrates. The untreated polyurethane film surface was rough (RMS = 690 nm) and highly hydrophobic (contact angle theta = 90 degrees). Cell growth on the untreated polyurethane surface was poor (cell concentration approximately 3750/cm2) compared to glass surface (cell concentration approximately 17 665/cm2). The atmospheric helium plasma treatment of the polyurethane film resulted in oxidation of the surface, a slight increase in roughness (RMS = 735 nm) and a significant drop in hydrophobicity (contact angle theta = 79 degrees). The critical surface tension (gamma c) of polyurethane film was also increased by 2 dynes/cm due to helium plasma treatment. These changes resulted in enhanced HCAE cell growth in polyurethane film (cell concentration approximately 16 230/cm2) compared to the untreated polyurethane film. The cell growth was also comparable to cell growth on a glass surface (17 665/cm2) and the collagen-treated polyurethane film surfaces (cell concentration approximately 21 645/cm2), respectively. Moreover, the strength of cell attachment on a plasma-treated surface (cell retention R = 89%) under laminar flow was significantly higher than that on a glass surface (R = 71%). While the collagen-treated polyurethane surface had the highest number of HCAE cells, the cell adhesion was found to be poor (R = 42%) compared to that of a plasma-treated surface. Thus, the overall performance of the plasma-treated polyurethane film surface on endothelial cell growth was better than other substrates studied here.