Related Experiment Video
Updated: Aug 15, 2026

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
A physiological model of gas pockets in crevices and their behavior under compression
1Department of Engineering Science, University of Oxford, Parks Road, Oxford OX1 3PJ, UK. michael.chappell@eng.ox.ac.uk
Abstract:
The formation of bubbles in the body from dissolved gases during decompression causes a range of symptoms, often referred to as Decompression Sickness. It is likely that these bubbles grow from pre-existing nuclei. It has been proposed that such nuclei are pockets of gas that are stabilized against collapse under raised pressure, such as that experienced by deep-sea divers. This work explores the stabilization of gas pockets in crevices, in its application to the nucleation of bubbles in blood vessels. A model has been derived to describe the dynamics of a bubble in a crevice, assuming that gases diffuse in and out of the bubble via the crevice wall from the body tissues surrounding the crevice. The time-varying behavior of the bubble has been examined and it has been shown that a crevice bubble can survive compression by temporary variations in the gas-liquid interface curvature or by shrinking, its behavior being found to be strongly dependent upon the model parameters.
Related Concept Videos
Physical Principles Governing Gas Exchange
Gas Laws Governing Respiration
The behavior of gases is guided by Dalton's Law of partial pressures and Henry's Law.
Dalton's Law asserts that the total pressure exerted by...
The Kinetic Model of Gases
Mechanistic Models: Overview of Compartment Models
Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation
Compartment Models: Single-Compartment Model
Van der Waals Equation
First, the attractive forces between molecules, which are stronger at higher densities and reduce the pressure, are considered by adding to the pressure a term equal to the square of the molar density multiplied by a positive coefficient a. Second, the volume...

