Allometry for sexual size dimorphism: testing two hypotheses for Rensch's rule in the water strider Aquarius remigis

Daphne J Fairbairn1

  • 1Department of Biology, University of California, Riverside, California 92521,USA. daphne.fairbairn@ucr.edu

The American Naturalist
|October 15, 2005
PubMed

Related Concept Videos

Testing a Claim about Mean: Unknown Population SD01:21

Testing a Claim about Mean: Unknown Population SD

A complete procedure of testing a hypothesis about a population mean when the population standard deviation is unknown is explained here.
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used; instead...
The Ratio of X Chromosome to Autosomes02:45

The Ratio of X Chromosome to Autosomes

In most organisms, sex is determined by the ratio of X and Y chromosomes. However, in some organisms, such as Drosophila and C.elegans, sex is determined by the ratio of the number of X chromosomes to the number of sets of autosomes. The Y chromosome in Drosophila is active but does not determine sex. It contains genes responsible for the production of sperms in adult flies.  
Normal male Drosophila has a ratio of one X chromosome to two sets of autosomes. In contrast, normal female Drosophila...
Testing a Claim about Population Proportion01:24

Testing a Claim about Population Proportion

A complete procedure for testing a claim about a population proportion is provided here.
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Testing a Claim about Mean: Known Population SD01:11

Testing a Claim about Mean: Known Population SD

A complete procedure of testing the hypothesis about a population mean is explained here.
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
Mate Choice01:20

Mate Choice

Mate choice—the decision about whom to mate with—is a type of natural selection, since animals must reproduce to pass down their genes. Mate choice is also called intersexual selection because the behavior occurs between the sexes.
Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...