Importance of dynamic surface tension to the residual water content of fabrics

At the end of the final spin cycle of the laundry process, the residual moisture content (RMC) of fabric is directly related to the dynamic surface tension of the residual water in the fabric. The LaPlace equation for capillary rise predicts that the capillary rise of solutions in a capillary is proportional to the surface tension at the air-liquid interface. If fabric can be considered to be a large ensemble of capillaries due to interfiber spacing, then the RMC of fabrics will be directly related to the surface tension of residual solution in the fabric. The use of a tailored rinse additive has the potential to decrease the surface tension of solution significantly, thus leading to a decrease in the residual water content of the fabric. It is expected that as the surfactant concentration increases the surface tension decreases. Hence, the RMC of fabrics must decrease with increasing surfactant concentration. However, a peak is observed in the RMC of fabrics before the critical micelle concentration (CMC) is reached. Prior to the CMC, it is proposed that a sudden adsorption of surfactant is occurring on the fabric surface leading to a decrease in bulk monomer concentration. The decrease in free monomer concentration should result in an increase in the equilibrium surface tension of the residual solution leading to a concomitant increase in RMC. Because the dynamic surface tension is measured on a short time scale (on the order of milliseconds), there will be less adsorption of monomer onto the newly created air-liquid interface of the bubbles during the measurement process. This decrease in adsorption should lead to a pronounced increase in the dynamic surface tension. This indeed was observed. The RMC correlates very well with the dynamic surface tension of the residual solution.