Related Experiment Video

Updated: Aug 14, 2026

A Flow-through Exposure System for Evaluating Suspended Sediments Effects on Aquatic Life
12:15

A Flow-through Exposure System for Evaluating Suspended Sediments Effects on Aquatic Life

Published on: January 9, 2017

Using sediment quality guidelines for dredged material management in commercial ports from Spain

M C Casado-Martínez1, J L Buceta, M J Belzunce

  • 1Departamento de Química-Física, Facultad de Ciencias del Mar y Ambientales (Universidad de Cádiz), Polígono Río San Pedro, s/n. 11510 Puerto Real (Cádiz), Spain.

Environment International
|November 18, 2005
PubMed

More Related Videos

The Floating Lab: Standard Operational Procedure for Collecting and Filtering Seawater Samples from Operating Ferries for Environmental DNA Analysis06:22

The Floating Lab: Standard Operational Procedure for Collecting and Filtering Seawater Samples from Operating Ferries for Environmental DNA Analysis

Published on: August 1, 2025

Protocol for Microplastics Sampling on the Sea Surface and Sample Analysis10:16

Protocol for Microplastics Sampling on the Sea Surface and Sample Analysis

Published on: December 16, 2016

Related Concept Videos

Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
Deleterious Substances in Aggregate01:25

Deleterious Substances in Aggregate

Deleterious substances in aggregates can be detrimental to the quality and durability of concrete. These substances include organic impurities like loam, which interfere with cement hydration and are usually present in the sand. These prevent a good bond between aggregate and cement paste. Organic impurities can be detected using the colorimetric test, where the darkness of a solution after agitation indicates the level of organic content.
Another type of impurity is clay and fine material that...
Design Example: Aggregate Gradation01:24

Design Example: Aggregate Gradation

The right type and quality of aggregates are crucial for concrete as they significantly influence its properties, mix proportions, and cost-effectiveness. If different sources are available for sand, the commonly used fine aggregate in concrete, the selection of sand is primarily based on its gradation.
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is sampled...