An EPR and ENDOR study of gamma- and beta-radiation sterilization in poly (lactide-co-glycolide) polymers and
James A Bushell1, Mike Claybourn, Helen E Williams
1School of Chemistry, Cardiff University, UK.
Abstract:
EPR/ENDOR spectroscopy was used to characterise the free radicals generated in a series of PLGA raw polymers and microspheres (with lactide:glycolide compositions of (75:25), (65:35) and (50:50)) after exposure to gamma (gamma-) and electron beam (beta-) irradiation at room temperature. Both sets of irradiated samples produced analogous EPR spectra, indicating that the type and distribution of free radicals generated by gamma-irradiation are similar to those generated by beta-irradiation. The radicals were identified by EPR simulations as the chain scission species -(CHO-(approximately 27% abundance),-C(CH(3))O- ( approximately 23% abundance) and the terminal-C(CH(3))-OR fragment (approximately 50% abundance), and these assignments were supported by the ENDOR analysis. The latter two radical species were demonstrated to originate from the lactide component of the PLGA polymer. Overall systematically higher radical concentrations were found as the lactide content of the PLGA raw polymer and microspheres increases (ie., 75:25 > 65:35 > 50:50) for both gamma- and beta-irradiation. However, while the relative concentrations of free radicals was similar in the raw polymer samples after exposure to gamma- or beta-irradiation, a substantial difference was found for the microsphere samples; an approximate doubling of the radical content was found in the gamma-irradiated PLGA microspheres compared to the identical beta-irradiated microspheres.
Related Concept Videos
01:30Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
01:26Physical Methods for Controlling Microbial Growth: Radiation and Filtration
01:29Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...