Related Experiment Video
Updated: Aug 14, 2026

Dispersion of Nanomaterials in Aqueous Media: Towards Protocol Optimization
Published on: December 25, 2017
Stability of nanodispersions: a model for kinetics of aggregation of nanoparticles
1Department of Chemistry, Faculty of Science, University of Zagreb, Marulićev trg 19, P.O. Box 163, Zagreb, HR 10000, Croatia. nkallay@prelog.chem.pmf.hr
Abstract:
In the course of aggregation of very small colloid particles (nanoparticles) the overlap of the diffuse layers is practically complete, so that one cannot apply the common DLVO theory. Since nanopoarticles are small compared to the extent of the diffuse layer, the process is considered in the same way as for two interacting ions. Therefore, the Brønsted concept based on the Transition State Theory was applied. The charge of interacting nanoparticles was calculated by means of the Surface Complexation Model and decrease of effective charge of particles was also taken into account. Numerical simulations were performed using the parameters for hematite and rutile colloid systems. The effect of pH and electrolyte concentration on the stability coefficient of nanosystems was found to be more pronounced but similar to that for regular colloidal systems. The effect markedly depends on the nature of the solid which is characterized by equilibrium constants of surface reactions responsible for surface charge, i.e., by the point of zero charge, while the specificity of counterions is described by their association affinity, i.e., by surface association equilibrium constants. The most pronounced is the particle size effect. It was shown that extremely small particles cannot be stabilized by an electrostatic repulsion barrier. Additionally, at the same mass concentration, nanoparticles aggregate more rapidly than ordinary colloidal particles due to thier higher number concentration.
Related Concept Videos
The Colloidal State
Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model
Colloidal precipitates
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...

