Failure-tolerant performance stabilization of the generic large-scale system by decentralized linear output feedback
Related Experiment Videos
Yazdan Bavafa-Toosi1, Hiromitsu Ohmori, Batool Labibi
1School of Integrated Design Engineering, Graduate School of Science and Technology, Keio University, Hiyoshi, Kohoku-Ku, Yokohama, Kanagawa, Japan. ybavafat@contr.sd.keio.ac.jp
Abstract:
Most of the existing results on the decentralized stabilization of large-scale systems consider systems in the input-output-decentralized form, i.e., systems whose input and output matrices are block diagonal. The controller synthesis for such systems is less involved than that for input-output-centralized ones. In this paper, a transformation is proposed for the input-output decentralization of the generic large-scale system. Using the transformed system, a sufficient condition for failure-tolerant performance stabilization of the original large-scale system in a desirable performance region under decentralized linear output feedback is established. The problem is then reformulated as a constrained nonlinear optimization problem. The proposed methodology results in the optimal reconciliation of failure-tolerant performance stabilization of the overall system, and reliability and low actuator gains of the isolated subsystems. The effectiveness of the proposed approach is demonstrated by an example.
Related Concept Videos
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Effects of feedback
Feedback significantly modifies the gain of a control system. The gain of a system without feedback is altered by a factor of one plus GH, where G represents...
Control Systems
At the heart...
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
Classification of Systems-I
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal and...