Influence of process variable and physicochemical properties on the granulation mechanism of mannitol in a fluid bed...

This study investigated the influence of specific process variables, including the hydroxypropyl cellulose (HPC) binder solution atomization, on the fluidized bed top spray granulation of mannitol. Special attention was given to the relationship between wetting and the granule growth profile. The atomization of the HPC binder solution using a binary nozzle arrangement produced droplets of decreasing size as the atomization pressure was increased, while changes in the spray rate had little effect on the mean droplet size. Increasing the HPC binder concentration from 2 to 8% w/w increased the binder droplet size and was most likely attributed to higher solution viscosity. The top spray granulation of mannitol showed induction type growth behavior. Process conditions like high spray rate, low fluidizing air velocity and binder solution concentration that promote the availability of HPC binder solution at the surface of the particles appeared to be key in enhancing nucleation and growth of the granules. Increasing the bed moisture level, up to a certain value, reduced the contribution of attrition to the overall growth profile of the granule and, more significantly, produced less granule breakage on drying. It was observed that the mean granule size could be reduced as much as 40% between the end of granulation and the end of drying for lower initial bed moisture level despite a shorter drying phase. High atomization pressure, especially when maintained during the drying phase, contributed substantially to granule breakage.