Related Experiment Video
Updated: Aug 14, 2026

In Vivo Intracellular Recording of Type-Identified Rat Spinal Motoneurons During Trans-Spinal Direct Current Stimulation
Published on: May 11, 2020
Simulation of Ca2+ persistent inward currents in spinal motoneurones: mode of activation and integration of synaptic
Sherif M Elbasiouny1, David J Bennett, Vivian K Mushahwar
1Department of Biomedical Engineering, University of Alberta, Edmonton, Canada.
Abstract:
The goal of this study was to investigate the nature of activation of the dendritic calcium persistent inward current (Ca(2+) PIC) and its contribution to the enhancement and summation of synaptic inputs in spinal motoneurones. A compartmental cable model of a cat alpha-motoneurone was developed comprising the realistic dendritic distribution of Ia-afferent synapses and low-voltage-activated L-type calcium (Ca(v)1.3) channels distributed over the dendrites in a manner that was previously shown to match a wide set of experimental measurements. The level of synaptic activation was systematically increased and the resulting firing rate, somatic and dendritic membrane potentials, dendritic Ca(v)1.3 channel conductance, and dendritic Ca(2+) PIC were measured. Our simulation results suggest that during cell firing the dendritic Ca(2+) PIC is not activated in an all-or-none manner. Instead, it is initially activated in a graded manner with increasing synaptic input until it reaches its full activation level, after which additional increases in synaptic input result in minimal changes in the Ca(2+) PIC (PIC saturated). The range of graded activation of Ca(2+) PIC occurs when the cell is recruited and causes a steep increase in the firing frequency as the synaptic current is increased, coinciding with the secondary range of the synaptic frequency-current (F-I) relationship. Once the Ca(2+) PIC is saturated the slope of the F-I relationship is reduced, corresponding to the tertiary range of firing. When the post-spike afterhyperpolarization (AHP) is blocked, either directly by blocking the calcium-activated potassium channels, or indirectly by blocking the sodium spikes, the PIC is activated in an all-or-none manner with increasing synaptic input. Thus, the AHP serves to limit the depolarization of the cell during firing and enables graded, rather than all-or-none, activation of the Ca(2+) PIC. The graded activation of the Ca(2+) PIC with increasing synaptic input results in a graded (linear) enhancement and linear summation of synaptic inputs. In contrast, the saturated Ca(2+) PIC enhances synaptic inputs by a constant amount (constant current), and leads to less-than linear summation of multiple synaptic inputs. These model predictions improve our understanding of the mode of activation of the dendritic Ca(2+) PIC and its role in the enhancement and integration of synaptic inputs.
More Related Videos
Related Concept Videos
The Role of Ion Channels in Neuronal Computation
Sometimes a single EPSP is strong enough to induce an action potential in the postsynaptic neuron. However, multiple presynaptic inputs must often create EPSPs around the same time for the postsynaptic neuron to be sufficiently depolarized to fire an action potential.
Action Potential
Membrane potential in neurons
Neurons typically have a resting membrane potential of about -70 millivolts (mV). When they receive...
Action Potential
Membrane potential in neurons
Neurons typically have a resting membrane potential of about -70 millivolts (mV). When they receive...
Action Potentials
Spinal Cord: Information Processing
Sensory Information Processing
Sensory information processing begins at the sensory receptors located in the skin and other tissues, which detect somatic sensory stimuli such as touch, temperature, or pain. These receptors function as catalysts, initiating...

