Press chamber coating as external lubrication for high speed rotary presses: lubricant spray rate optimization

Lubrication of the tooling (punches and dies) is necessary to produce tablets. The most commonly used lubricant is magnesium stearate. Adding and blending magnesium stearate to the tablet mass often has negative effects on the properties of the compressed tablets (e.g., decreasing the tensile strength of the tablet). To avoid these negative effects, external lubrication systems were developed. This study investigated the functionality and the influence of a new press chamber coating system called the PKB II. The major difference between the PKB II and previous systems is its ability to spray a mixture of powdered magnesium stearate and air directly onto the punches and dies which was determined to allow the running of the rotor at higher speeds. The data showed a clear correlation between the spray rate of the lubricant and the concentration of the magnesium stearate per tablet. The PKB II was designed to allow for adjustments, in order to optimize the spray rate, by using the ejection force. The concentration of magnesium stearate was reduced to approximately 0.04% per tablet, using the PKB II. Additionally, the most common negative effects, such as the decrease in tablet tensile strength, were avoided by using this system.