Slowing of the Atlantic meridional overturning circulation at 25 degrees N

Harry L Bryden1, Hannah R Longworth, Stuart A Cunningham

  • 1National Oceanography Centre, Empress Dock, Southampton SO14 3ZH, UK. h.bryden@noc.soton.ac.uk

Nature
|December 2, 2005
PubMed

Related Concept Videos

Net Torque Calculations01:19

Net Torque Calculations

When a mechanic tries to remove a hex nut with a wrench, it is easier if the force is applied at the farthest end of the wrench handle. The lever arm is the distance from the pivot point (the hex nut in this case) to the person’s hand. If this distance is large, the torque is higher. Only the component of the force perpendicular to the lever arm contributes to the torque. Therefore, pushing the wrench perpendicular to the lever arm is more advantageous. If multiple people apply force to rotate...
Coriolis Force01:23

Coriolis Force

An accelerating particle experiences a force equal to the mass multiplied by the acceleration in an inertial frame of reference. Consider a particle in a non-inertial frame of reference, such as a sliding ball on a rotating table. The acceleration of the ball in this rotating reference frame is different than in the intertial frame, which modifies its equation of motion. The fictitious forces acting additionally on a rotating frame of reference alter Newton's Second Law expression. Centripetal...
Angle of Twist: Problem Solving01:13

Angle of Twist: Problem Solving

An electric motor applies a torque of 700 N·m to an aluminum shaft, triggering a stable rotation. Two pulleys, B and C, are subjected to torques of 300 N·m and 400 N·m, respectively. The modulus of rigidity is provided as 25 GPa. With the knowledge of the length and diameter of each segment, the twist angle between the two pulleys can be computed. First, a section cut is made between pulleys B and C, and the cut cross-section is analyzed using a free-body diagram. Given that the torque exerted...
Transformers with Off-Nominal Turns Ratios01:25

Transformers with Off-Nominal Turns Ratios

In scenarios involving parallel transformers with disparate ratings, developing per-unit models requires accommodating off-nominal turns ratios. This situation arises when the selected base voltages are not proportional to the transformer’s voltage ratings. Consider a transformer where the rated voltages are related by the term a. If the chosen voltage bases satisfy a relationship involving term b, term c is defined as the ratio of these bases. This ratio is then substituted into the rated...
Magnetic Declination01:19

Magnetic Declination

Magnetic declination is the angle between true north, which aligns with the Earth's rotational axis, and magnetic north, which follows the direction of the Earth's magnetic field. This discrepancy exists because the magnetic poles do not coincide with the geographic poles. The value of magnetic declination depends on the observer's location on Earth and is subject to changes over time due to the dynamic nature of the Earth's magnetic field.The declination is called eastern when magnetic north...
Vectors in 2D: Problem Solving01:29

Vectors in 2D: Problem Solving

A plane traveling due north at 180 km/h in still air was found to be 80 km off-course after 30 minutes, deviating approximately 5 degrees east of north. This deviation means the influence of a crosswind alters the plane’s intended trajectory. The actual ground path formed a diagonal, suggesting that the aircraft’s effective ground speed was reduced to 160 km/h and directed slightly to the east due to the wind.By analyzing the displacement from the intended path, the velocity contributed by the...