Purification and Characterization of alpha-Amylase from Bacillus licheniformis CUMC305

alpha-Amylase produced by Bacillus licheniformis CUMC305 was purified 212-fold with a 42% yield through a series of four steps. The purified enzyme was homogeneous as shown by sodium dodecyl sulfate-polyacrylamide gel electrophoresis and discontinuous gel electrophoresis. The purified enzyme showed maximal activity at 90 degrees C and pH 9.0, and 91% of this activity remained at 100 degrees C. The enzyme retained 91, 79, and 71% maximal activity after 3 h of treatment at 60 degrees C, 3 h at 70 degrees C, and 90 min at 80 degrees C, respectively, in the absence of substrate. On the contrary, in the presence of substrate (soluble starch), the alpha-amylase enzyme was fully stable after a 4-h incubation at 100 degrees C. The enzyme showed 100% stability in the pH range 7 to 9; 95% stability at pH 10; and 84, 74, 68, and 50% stability at pH values of 6, 5, 4, and 3, respectively, after 18 h of treatment. The activation energy for this enzyme was calculated as 5.1 x 10 J/mol. The molecular weight was estimated to be 28,000 by sodium dodecyl sulfate-gel electrophoresis. The relative rates of hydrolysis of soluble starch, amylose, amylopectin, and glycogen were 1.27, 1.8, 1.94, and 2.28 mg/ml, respectively. V(max) values for hydrolysis of these substrates were calculated as 0.738, 1.08, 0.8, and 0.5 mg of maltose/ml per min, respectively. Of the cations, Na, Ca, and Mg, showed stimulatory effect, whereas Hg, Cu, Ni, Zn, Ag, Fe, Co, Cd, Al, and Mn were inhibitory. Of the anions, azide, F, SO(3), SO(4), S(2)O(3), MoO(4), and Wo(4) showed an excitant effect. p-Chloromercuribenzoic acid and sodium iodoacetate were inhibitory, whereas cysteine, reduced glutathione, thiourea, beta-mercaptoethanol, and sodium glycerophosphate afforded protection to enzyme activity. alpha-Amylase was fairly resistant to EDTA treatment at 30 degrees C, but heating at 90 degrees C in presence of EDTA resulted in the complete loss of enzyme activity, which could be recovered partially by the addition of Cu and Fe but not by the addition of Ca or any other divalent ions.