Related Experiment Video
Updated: Aug 14, 2026

Measurement of the Potential Rates of Dissimilatory Nitrate Reduction to Ammonium Based on 14NH4+/15NH4+ Analyses via Sequential Conversion to N2O
Published on: October 7, 2020
Measurement of nitrous oxide reductase activity in aquatic sediments
L G Miller1, R S Oremland, S Paulsen
1Water Resources Division, U.S. Geological Survey, Menlo Park, California 94025, and Division of Environmental Studies, University of California at Davis, Davis, California 95616.
Abstract:
Denitrification in aquatic sediments was measured by an N(2)O reductase assay. Sediments consumed small added quantities of N(2)O over short periods (a few hours). In experiments with sediment slurries, N(2)O reductase activity was inhibited by O(2), C(2)H(2), heat treatment, and by high levels of nitrate (1 mM) or sulfide (10 mM). However, ambient levels of nitrate (<100 muM) did not influence activity, and moderate levels (about 150 muM) induced only a short lag before reductase activity began. Moderate levels of sulfide (<1 mM) had no effect on N(2)O reductase activity. Nitrous oxide reductase displayed Michaelis-Menten kinetics in sediments from freshwater (K(m) = 2.17 muM), estuarine (K(m) = 14.5 muM), and alkaline-saline (K(m) = 501 muM) environments. An in situ assay was devised in which a solution of N(2)O was injected into sealed glass cores containing intact sediment. Two estimates of net rates of denitrification in San Francisco Bay under approximated in situ conditions were 0.009 and 0.041 mmol of N(2)O per m per h. Addition of chlorate to inhibit denitrification in these intact-core experiments (to estimate gross rates of N(2)O consumption) resulted in approximately a 14% upward revision of estimates of net rates. These results were comparable to an in situ estimate of 0.022 mmol of N(2)O per m per h made with the acetylene block assay.

