Related Experiment Video
Updated: Aug 14, 2026

Fabrication and Design of Wood-Based High-Performance Composites
Published on: November 9, 2019
Palo Podrido: Model for Extensive Delignification of Wood by Ganoderma applanatum
1Institut für Biochemie und Molekulare Biologie, Abteilung Botanik, Technische Universität Berlin, D-1000 Berlin 12, Federal Republic of Germany.
Abstract:
Chemical and micromorphological analysis revealed that South Chilean "palo podrido" results from a white-rot fungus that causes highly selective and extensive delignification. Palo podrido samples from 10 different hardwood trunks (Eucryphia cordifolia, Drimys winteri, and Nothofagus dombeyi) decayed by Ganoderma applanatum were analyzed. Of 14 samples, 11 had extremely low Klason lignin values, ranging from 6.1 to 0.4% (dry weight). The most remarkable and unusual feature was that delignification and defibration were not restricted to small pockets but extended throughout large areas in the interior of trunks subjected to undisturbed rotting over long periods of time. Comparative analysis of water content, swelling capacity, and lignin content led to the conclusion that besides lignin degradation, suppression of the cellulolytic activity of the rotting organisms plays a decisive role. Among various nutrients added to a palo podrido sample (3% residual Klason lignin), the nitrogen source was the only one leading to almost complete cellulose degradation. We suggest that the extremely low nitrogen content (0.037 to 0.073% [dry weight]) of the investigated wood species was the primary cause for the extensive delignification as well as the concomitant suppression of cellulose breakdown. The low temperatures, high humidity, and microaerobic conditions maintained within the decaying trunks are discussed as additional ecological factors favoring delignification in South Chilean rain forests.
Related Concept Videos
Wood Products
Glue-laminated wood, often referred to as glulam, combines multiple smaller pieces of dimensional lumber using adhesives to form a single, larger piece. Cross-laminated timber consists...
Wood Surfacing
The equipment used in the surfacing process is a plane equipped with rotating blades. This tool efficiently smoothens the wood surface and can...
Introduction to Wood
The structural integrity of the wood...
Lumber Defects
Shakes are minor fractures that run along or across the wood's annual rings, while wane is...
Lumber
Initially, the surfaces of these lumber pieces are rough, and their dimensions may vary slightly from one end to...
Seasoning of Wood
Achieving equilibrium moisture content is the goal of seasoning; this is the point where the wood's moisture content stabilizes to align with the moisture levels of the surrounding environment. Proper...

