Direct experimental evidence of a growing length scale accompanying the glass transition

L Berthier1, G Biroli, J-P Bouchaud

  • 1Laboratoire des Colloïdes, Verres, et Nanomatériaux, UMR 5587, Université Montpellier II and CNRS, 34095 Montpellier, France. berthier@lcvn.univ-montp2.fr

Science (New York, N.Y.)
|December 17, 2005
PubMed

Related Concept Videos

Glassware Calibration01:11

Glassware Calibration

Accurate calibration of glassware, such as volumetric flasks, pipettes, and burettes, is essential to ensure accurate measurements in the analytical laboratory. Calibration helps maintain consistency across measurements and prevents errors arising from inaccurate volumes.
Volumetric flasks: Volumetric flasks are designed to prepare aqueous solutions of precise volumes accurately with a calibration line on the neck. To calibrate a volumetric flask, it is important to fill it with distilled...
Stress-Strain Diagram - Brittle Materials01:24

Stress-Strain Diagram - Brittle Materials

Brittle materials, including glass, cast iron, and stone, exhibit unique characteristics. They fracture without considerable change in their elongation rate, indicating that their breaking and ultimate strength are equivalent. Such materials also show lower strain levels at the point of rupture. The failure in brittle materials predominantly results from normal stresses, as evidenced by the rupture created along a surface perpendicular to the applied load. These materials do not display...
Crystal Density01:19

Crystal Density

The crystal lattice structure of a material allows us to determine how many molecules exist in its unit cell. With this information, alongside the unit-cell parameters - three distance parameters (a, b, c) and three angular parameters (α, β, γ).Density (ρ) = (Z × M) / (a × b × c × NA)where:Z is the number of formula units per unit cellM is the molar mass of the substancea, b, and c are the edge lengths of the unit cellNA is Avogadro’s numberFor a simple cubic lattice, atoms are located only at...
Porosity and Absorption of Aggregate01:20

Porosity and Absorption of Aggregate

Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the aggregate...
Transition Zone01:28

Transition Zone

The transition zone in concrete is a critical area where aggregate meets cement paste, marked by a distinct porosity and weakness compared to the surrounding material. The adhesion around the aggregates is primarily due to Van Der Waals forces. The voids within this zone influence its robustness; initially, it is less durable than the surrounding bulk mortar due to larger voids. Initially, when concrete is compacted, a higher water-cement ratio near the aggregates leads to the formation of...