Cosorption of atrazine and a lauryl polyoxyethylene oxide nonionic surfactant on smectite

Mark A Chappell1, David A Laird, Michael L Thompson

  • 1Department of Agronomy, Agronomy Hall, Iowa State University, Ames, Iowa, 50011, USA. machap@iastate.edu

Related Concept Videos

Surface Active Agents01:27

Surface Active Agents

Surfactants, named for their behavior at interfaces, positively adsorb at the interfaces of two phases, reducing interfacial tension. Their versatility as emulsifiers, detergents, and foaming agents stems from this ability. Surfactants, often termed amphiphiles, share the property of amphipathy, with molecules having both hydrophilic and hydrophobic portions. The hydrophilic part is called the head, and the hydrophobic part, including an elongated alkyl substituent, forms the tail.Surfactants...
Factors Affecting Solubility04:01

Factors Affecting Solubility

Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:
Colloidal precipitates01:09

Colloidal precipitates

The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
Precipitation Titration: Endpoint Detection Methods01:19

Precipitation Titration: Endpoint Detection Methods

In argentometric precipitation titrations, endpoints can be detected visually by the Mohr, Volhard, and Fajans methods. In the Mohr method, adding a soluble chromate indicator gives an initial yellow color to the analyte solution. As the titrant is added, the first excess of silver ions forms a red silver chromate precipitate, marking the endpoint. The solution pH should be maintained at about 8 by adding solid CaCO3.
In the Volhard method, a standard excess of AgNO3 is first added to the...