Related Experiment Video
Updated: Aug 13, 2026

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
Utilization of municipal solid waste bottom ash and recycled aggregate in concrete
1Faculty of Civil Engineering, University of Maribor, Smetanova 17, 2000 Maribor, Slovenia; Projekt d.d. Nova Gorica, Kidriceva 9a, 5000 Nova Gorica, Slovenia.
Abstract:
In the combustion process of municipal solid waste (MSW), bottom ash (BA) represents the major portion of the solid residue. Since BA is composed of oxides, especially SiO(2) and CaO, the feasibility of its application in concrete as a substitute for cement was tested. It was found that at the age of 28 days, the flexural and compressive strengths of the binder linearly decrease at the rate of 0.03 and 0.02 MPa per wt% of BA in the binder, respectively. According to the results it may be recommended to replace up to 15 wt% of cement by BA and to use such binder where a low strength of concrete elements is required. Furthermore, the aggregate used for low strength concrete need not be of a very good quality. Therefore, gravel aggregate was partially replaced by recycled aggregate (RA). Consistency measured by slump was significantly reduced (>50%) when BA or/and RA were introduced into the mixture. However, concrete density and compressive strength were not affected and were approximately 2300 kg/m(3) and approximately 40 MPa, respectively.
Related Concept Videos
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Aggregate Cement Ratio
Concrete
Aggregates Classification
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
Preplaced Aggregate Concrete
Additives and Fillers in Concrete
The...

