Related Experiment Video
Updated: Aug 11, 2026

Flow-assisted Dielectrophoresis: A Low Cost Method for the Fabrication of High Performance Solution-processable Nanowire Devices
Published on: December 7, 2017
Diameter-dependent electromechanical properties of GaN nanowires
Chang-Yong Nam1, Papot Jaroenapibal, Douglas Tham
1Department of Materials Science and Engineering, University of Pennsylvania, 3231 Walnut Street, Philadelphia, Pennsylvania 19104-6272, USA.
Abstract:
The diameter-dependent Young's modulus, E, and quality factor, Q, of GaN nanowires were measured using electromechanical resonance analysis in a transmission electron microscope. E is close to the theoretical bulk value ( approximately 300 GPa) for a large diameter nanowire (d=84 nm) but is significantly smaller for smaller diameters. At room temperature, Q is as high as 2,800 for d=84 nm, significantly greater than what is obtained from micromachined Si resonators of comparable surface-to-volume ratio. This implies significant advantages of smooth-surfaced GaN nanowire resonators for nanoelectromechanical system (NEMS) applications. Two closely spaced resonances are observed and attributed to the low-symmetry triangular cross section of the nanowires.

