Related Experiment Video

Updated: Jul 17, 2026

Atomic Scale Structural Studies of Macromolecular Assemblies by Solid-state Nuclear Magnetic Resonance Spectroscopy
14:55

Atomic Scale Structural Studies of Macromolecular Assemblies by Solid-state Nuclear Magnetic Resonance Spectroscopy

Published on: September 17, 2017

Solution state structure determination of silicate oligomers by 29SI NMR spectroscopy and molecular modeling

Herman Cho1, Andrew R Felmy, Raluca Craciun

  • 1Pacific Northwest National Laboratory, P.O. Box 999, Richland, WA 99352, USA. hm.cho@pnl.gov

Journal of the American Chemical Society
|February 16, 2006
PubMed

More Related Videos

Biochemical and Structural Characterization of the Carbohydrate Transport Substrate-binding-protein SP009208:53

Biochemical and Structural Characterization of the Carbohydrate Transport Substrate-binding-protein SP0092

Published on: October 2, 2017

Standardized Identification of Compound Structure in Tibetan Medicine Using Ion Trap Mass Spectrometry and Multiple-Stage Fragmentation Analysis09:24

Standardized Identification of Compound Structure in Tibetan Medicine Using Ion Trap Mass Spectrometry and Multiple-Stage Fragmentation Analysis

Published on: March 17, 2023

Related Concept Videos

Molecular Models02:00

Molecular Models

Physical models representing molecular architectures of chemical compounds play essential roles in understanding chemistry. The use of molecular models makes it easier to visualize the structures and shapes of atoms and molecules.
Determining the pH of Salt Solutions04:08

Determining the pH of Salt Solutions

The pH of a salt solution is determined by its component anions and cations. Salts that contain pH-neutral anions and the hydronium ion-producing cations form a solution with a pH less than 7. For example, in ammonium nitrate (NH4NO3) solution, NO3− ions do not react with water whereas NH4+ ions produce the hydronium ions resulting in the acidic solution. In contrast, salts that contain pH-neutral cations and the hydroxide ion-producing anions form a solution with a pH greater than 7. For...
Spectroscopy of Carboxylic Acid Derivatives01:26

Spectroscopy of Carboxylic Acid Derivatives

Infrared spectroscopy is primarily used to determine the types of bonds and functional groups. In carboxylic acid derivatives, a typical carbonyl bond absorption is observed around 1650–1850 cm−1. For esters, the absorption is recorded at around 1740 cm−1, while acid halides show the absorption at about 1800 cm−1. Another acid derivative, the acid anhydrides, exhibit two carbonyl absorption around 1760 cm−1 and 1820 cm−1, arising from the symmetrical and unsymmetrical carbonyl vibration.
In the...
Structure of Amines01:19

Structure of Amines

The hybridized nitrogen atom in amines possesses a lone pair of electrons and is bound to three substituents with a bond angle of around 108°, which is less than the tetrahedral angle of 109.5°. However, the C–N–H bond angle is slightly larger at 112°, with a carbon–nitrogen bond length of 147 pm. This carbon–nitrogen bond length of of amines is longer than the carbon–oxygen bond of alcohols (143 pm) but shorter than alkanes’ carbon–carbon bond (154 pm). These aspects are illustrated in Figure...
NMR and Mass Spectroscopy of Carboxylic Acids01:30

NMR and Mass Spectroscopy of Carboxylic Acids

In ¹H NMR spectroscopy, acidic protons (–COOH) of carboxylic acids are highly deshielded and absorb far downfield, at around 9–12 ppm. The chemical shift value depends on the concentration and solvent used.
While α protons of carboxylic acids absorb at 2–2.5 ppm, β protons absorb further upfield.
Carboxylic acids are easily identified by dissolving them in deuterium oxide, which results in a rapid exchange of the acidic protons with deuterium. This leads to the disappearance of the acidic...
Mass Spectrum: Interpretation01:24

Mass Spectrum: Interpretation

An unknown compound can be established by identifying the molecular ion peak in the mass spectrum. The molecular ion peak is often weak or absent due to the predominance of fragmentation in high-energy electron beams. In such cases, a soft-energy electron beam can be used to scan the spectrum to enhance the intensity of the molecular ion peak. Additionally, chemical ionization, field ionization, and desorption ionization spectra are used to obtain a relatively intense molecular ion peak.To...