Related Experiment Video
Updated: Aug 10, 2026

Modified Experimental Conditions for Noise-Induced Hearing Loss in Mice and Assessment of Hearing Function and Outer Hair Cell Damage
Published on: February 10, 2023
Induced loudness reduction as a function of exposure time and signal frequency
1Institute for Hearing, Speech & Language and Department of Speech-Language Pathology & Audiology (106A FR), Northeastern University, Boston, Massachusetts 02115, USA.
Abstract:
Induced loudness reduction (ILR) is the decline in the loudness of a weaker tone induced by a preceding stronger tone. In this study we investigate how ILR depends on exposure time and signal frequency. For 12 listeners, successive magnitude estimation was used to measure the loudness of 70-dB-SPL test tones, presented with and without preceding 80-dB-SPL inducer tones at the same frequency. Experiment 1 measured the evolution of ILR over time at 0.5 kHz. The results suggest that ILR may begin after a single inducer presentation, and increases over at least 2 to 3 min as the inducer and test tones are repeated every few seconds. Following the cessation of the inducer, the recovery of loudness is slow and still incomplete after 1 min. Experiment 2 extended the measurements to additional signal frequencies. The results show that the amount of ILR and its evolution over time are approximately the same at frequencies from 0.5 to 8 kHz. Similarly, loudness matching showed no effect of frequency on ILR, which averaged 8.2 dB. These findings, together with previously noted similarities among ILR, ipsilaterally induced loudness adaptation, and temporary loudness shift, indicate that loudness reduction induced by stronger sounds is a very common phenomenon.
Related Concept Videos
Sound Intensity Level
The human ear can perceive an extensive range of sound intensity, necessitating the use of the logarithmic scale to define a physical quantity—the intensity level. It is a ratio of two intensities and hence a...
Applications of Logarithms
Frequency Response of a Circuit
The transfer function is pivotal in characterizing how these circuits react to various frequencies, facilitating a profound understanding of their behavior. An essential parameter is the time constant, signifying the...
Scaling
Basic Operations on Signals
Time Reversal mirrors a continuous-time signal about the vertical axis at t=0. This is achieved by substituting t with −t. For example, if a signal x(t) is considered, the time-reversed signal is x(−t). This operation can be graphically represented, showing the mirrored signal.
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any finite,...

