Microbial degradation of an aliphatic polyester with a high melting point, poly(tetramethylene succinate)

The biodegradability of poly(tetramethylene succinate) (PTMS), a synthetic aliphatic polyester with a high melting point, was evaluated. The ecological study showed that the distribution of PTMS-degrading microorganisms in soil environments was quite restricted compared with the distribution of microorganisms that degrade poly((epsilon)-caprolactone) (PCL), a polyester with a low melting point. However, in soil samples in which the formation of a clear zone was observed, PTMS-degrading microorganisms constituted 0.2 to 6.0% of the total number of microorganisms, which is very close to the percentage (0.8 to 8.0%) observed for PCL-degrading microorganisms. Five strains were isolated from colonies which formed distinct clear zones on agar plates with emulsified PTMS. In liquid cultures of the isolates with ground PTMS powder, strain HT-6, an actinomycete, showed the highest PTMS degrading activity. It assimilated about 60% of the ground PTMS powder after 8 days of cultivation. When a PTMS emulsion was used, a higher degradation rate was observed and more than 90% of the PTMS was assimilated in 6 days. PTMS degradation products were analyzed by gas chromatography, and it was found that 1,4-butanediol, 4-hydroxy n-butyrate, and succinic acid accumulated during cultivation. Degradation of PTMS film by the strain occurred in two steps: fragmentation and then the formation of hemispherical holes on the surface of the film. Strain HT-6 was also able to assimilate PCL and poly((beta)-hydroxybutyrate) (PHB). The crude enzyme showed a wide range of substrate specificity, being able to degrade low-molecular-weight PTMS, PCL, PHB, and even high-molecular-weight PTMS.