General equilibrium effects of a supply side GHG mitigation option under the Clean Development Mechanism

Govinda R Timilsina1, Ram M Shrestha

  • 1Canadian Energy Research Institute, Calgary, AB, Canada. gtimilsina@ceri.ca

Related Concept Videos

The Small x Assumption02:20

The Small x Assumption

If a reaction has a small equilibrium constant, the equilibrium position favors the reactants. In such reactions, a negligible change in concentration may occur if the initial concentrations of reactants are high and the Kc value is small. In such circumstances, the equilibrium concentration is approximately equal to its initial concentration. This estimation can be used to simplify the equilibrium calculations by assuming that some equilibrium concentrations are equal to the initial...
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
Microbes and Climate Change01:27

Microbes and Climate Change

Microorganisms are pivotal agents in Earth's biogeochemical cycles, significantly influencing climate dynamics through their metabolic activities. These microbes modulate the levels of key greenhouse gases by both contributing to and helping mitigate climate change.Microbial Contributions to Greenhouse Gas EmissionsRising global temperatures accelerate microbial metabolism, which, in turn, speeds up the decomposition of organic matter. This process releases carbon dioxide (CO₂) through...
Free Energy and Equilibrium00:55

Free Energy and Equilibrium

The free energy change for a process may be viewed as a measure of its driving force. A negative value for ΔG represents a driving force for the process in the forward direction, while a positive value represents a driving force for the process in the reverse direction. When ΔG is zero, the forward and reverse driving forces are equal, and the process occurs in both directions at the same rate (the system is at equilibrium).
The reaction quotient, Q, is a convenient measure of the status of an...
Free Energy and Equilibrium02:56

Free Energy and Equilibrium

The free energy change for a process may be viewed as a measure of its driving force. A negative value for ΔG represents a driving force for the process in the forward direction, while a positive value represents a driving force for the process in the reverse direction. When ΔGrxn is zero, the forward and reverse driving forces are equal, and the process occurs in both directions at the same rate (the system is at equilibrium).
Recall that Q is the numerical value of the mass action expression...
Free Energy Changes for Nonstandard States03:25

Free Energy Changes for Nonstandard States

The free energy change for a process taking place with reactants and products present under nonstandard conditions (pressures other than 1 bar; concentrations other than 1 M) is related to the standard free energy change according to this equation: