Fall-off from extrapolated values of all chemical reactions at very high temperatures
Abstract:
At high temperatures the breaking of chemical bonds becomes relatively easy and the slow step in a chemical reaction shifts to the rate at which energy can seep into the bond that is to break. This has been observed by various investigators. A new general theory of reactions is developed here to explain this limiting rate at high temperatures. In the case of cyclopropane and cyclobutane the theory leads to the conclusion that 20 degrees of freedom form a heat reservoir which feeds the energy into the carbon bond that is to break and that this rate becomes controlling above about 1200 degrees K. This would correspond to 20 of the 21 vibrational bonds of cyclopropane feeding energy into the carbon bond that is to break, and there would be no noticeable rise in the number of bonds for cyclobutane. This theory is especially important for shock tubes and detonations, where this falling-off from the extrapolated low temperature rate becomes glaringly obvious.
More Related Videos
Related Concept Videos
Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
Effect of Temperature Change on Reaction Rate
Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature from...
Clausius-Clapeyron Equation
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
Phase Transitions: Vaporization and Condensation


