The puzzling properties of supercooled and glassy water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...

Cohesion is the attraction between molecules of the same type, such as water molecules. Water molecules have an overall neutral charge but are polar molecule. An oxygen atom in one water molecule has a partial negative charge that can bind to a hydrogen atom with a partial positive charge in a second water molecule, forming a hydrogen bond. Each water molecule can form up to four hydrogen bonds with other water molecules. Hydrogen bonds are responsible for water's cohesive nature.
On a surface,...

Surface Tension
The various IMFs between identical molecules of a substance are examples of cohesive forces. The molecules within a liquid are surrounded by other molecules and are attracted equally in all directions by the cohesive forces within the liquid. However, the molecules on the surface of a liquid are attracted only by about one-half as many molecules. Because of the unbalanced molecular attractions on the surface molecules, liquids contract to form a shape that minimizes the number...

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...

A phase diagram combines plots of pressure versus temperature for the liquid-gas, solid-liquid, and solid-gas phase-transition equilibria of a substance. These diagrams indicate the physical states that exist under specific conditions of pressure and temperature and also provide the pressure dependence of the phase-transition temperatures (melting points, sublimation points, boiling points). Regions or areas labeled solid, liquid, and gas represent single phases, while lines or curves represent...

When a solute is added to a pure solvent (A), the mole fraction of A decreases. The mole fraction is the ratio of the number of moles of A to the total number of moles in the solution. This decrease in mole fraction leads to a reduction in A's chemical potential (μA).The changes in μA also affect the solution's colligative properties. Colligative properties are properties of a solution that depend only on the number of solute particles present, not their identity. Examples include boiling point...