Related Experiment Video
Updated: Aug 8, 2026
Systematic Approach to Identify Novel Antimicrobial and Antibiofilm Molecules from Plants' Extracts and Fractions to Prevent Dental Caries
Published on: March 31, 2021
Adhesive systems and secondary caries formation: Assessment of dentin bond strength, caries lesions depth and
Alessandra R Peris1, Fabio H O Mitsui, Maristela M Lobo
1Department of Restorative Dentistry, Amazon State University-UEA, Manaus, Amazonas, Brazil.
Objectives:
The present study evaluated the microtensile bond strength and caries formation on adhesive/dentin interfaces before and after dynamic chemical formation of secondary caries.
Methods:
Restorations were prepared on the dentin surface of 80 bovine incisors using four adhesive systems: two fluoride-free (Single Bond and Clearfil SE Bond) and two fluoride containing (Optibond Solo Plus and Clearfil Protect Bond). The restored teeth were then sectioned into multiple slabs that were further trimmed at the bonded interface to a cross-sectional area of 1 mm2. Half of the slabs were subjected to secondary caries formation using a pH cycling model (treated groups); while the other half was used as the control group (no pH cycling). The specimens designated for bond strength evaluation were subjected to microtensile bond strength test (muTBS). Caries lesions formation was assesses by polarized light microscopy at different depths from the adhesive-dentin bonded interface. The fluoride ion concentration was evaluated using the de/remineralization solutions (De/Re).
Results:
No differences in muTBS were observed among the adhesive systems in both the control and treated conditions. Secondary caries significantly reduced the values of muTBS for all adhesives (p<0.05). Optibond Solo Plus presented the lowest caries formation at 5 microm depth. Fluoride concentrations present in the De/Re were less than 0.03 ppm, regardless of the adhesive system tested.
Significance:
Bond strength values significantly decreased after in vitro secondary caries formation. Fluoride present in adhesive systems is not capable of inhibiting secondary caries or maintaining bond strength values following caries formation.
