Related Experiment Video
Updated: Aug 8, 2026

Phase-Dependent Control of Trap Depth and Persistent Luminescence in Strontium Aluminate Phosphors
Published on: December 5, 2025
Defect centres and thermoluminescence in CaSO4:Dy,Ag phosphor
B C Bhatt1, Bhushan Dhabekar, Rajesh Kumar
1Radiological Physics and Advisory Division, Bhabha Atomic Research Centre, Trombay, Mumbai 400 085, India. bcbhatt2003@yahoo.com
Abstract:
The defect centres formed in the TL phosphor CaSO4:Dy,Ag are studied using the technique of Electron Spin Resonance. The Ag co-doped phosphor exhibits three glow peaks around 130, 220 and 375 degrees C in contrast with the two glow peaks observed in the CaSO4:Dy phosphor at 130 and 220 degrees C at a gamma ray dose of 1Gy. ESR studies show that the additional peak at 375 degrees C correlates with a Ag2+ centre formed due to gamma irradiation and observable only below -170 degrees C. The Ag2+ centre is characterised by an axial g-tensor with principal values g(parallel) = 2.38 and g(perpendicular) = 2.41. ESR studies further indicate that the precursor to a centre observable at low temperature (-170 degrees C) appears to act as the recombination centre for the TL peak at 375 degrees C; this radical is characterised by the g-values g(parallel) = 2.0023 and g(perpendicular) = 2.0038 and is assigned to SO3- radical. It is observed that there is more incorporation of Ag in the CaSO4:Dy system as compared with that in pure CaSO4 system.
More Related Videos
13:06Visualization of miniSOG Tagged DNA Repair Proteins in Combination with Electron Spectroscopic Imaging (ESI)
Published on: September 24, 2015
09:41Isolation of Quartz Grains for Optically Stimulated Luminescence (OSL) Dating of Quaternary Sediments for Paleoenvironmental Research
Published on: August 2, 2021
Related Concept Videos
Photoluminescence: Applications
Fluorescence and Phosphorescence: Instrumentation
DNA Agarose Gel Electrophoresis
Gel extraction follows five major steps: running gel electrophoresis to separate fragments, isolating the individual bands, extracting DNA from those bands, and removing the dye and salts from the extracted mixture to obtain pure DNA.
In cloning experiments, both the insert and vector DNA...