Related Experiment Video

Updated: Aug 8, 2026

Experimental Methods of Dust Charging and Mobilization on Surfaces with Exposure to Ultraviolet Radiation or Plasmas
07:54

Experimental Methods of Dust Charging and Mobilization on Surfaces with Exposure to Ultraviolet Radiation or Plasmas

Published on: April 3, 2018

Ion energy distribution and gas heating in the cathode fall of a direct-current microdischarge

Tsuyohito Ito1, Mark A Cappelli

  • 1Mechanical Engineering Department, Stanford University, Stanford, California 94305-3032, USA. tsuyohito@stanford.edu

Physical Review. E, Statistical, Nonlinear, and Soft Matter Physics
|May 23, 2006
PubMed

More Related Videos

Implementation of a Hyperbolic Vortex Plasma Reactor for the Removal of Micropollutants in Water06:35

Implementation of a Hyperbolic Vortex Plasma Reactor for the Removal of Micropollutants in Water

Published on: July 25, 2025

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry07:17

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry

Published on: August 1, 2017

Related Concept Videos

Van de Graaff Generator01:15

Van de Graaff Generator

Van de Graaff generators (or Van de Graaffs) are devices used to demonstrate high voltage due to static electricity that can also be used for research. Robert Van de Graaff first built one in 1931 (based on original suggestions by Lord Kelvin) for use in nuclear physics research.
Van de Graaff uses both smooth and pointed surfaces, conductors, and insulators to generate large static charges and, hence, large voltages. A substantial excess charge can be deposited on the sphere because it moves...
Energy Stored in a Capacitor: Problem Solving01:26

Energy Stored in a Capacitor: Problem Solving

In 1749, Benjamin Franklin coined the word battery for a series of capacitors connected to store energy. Capacitors store electric potential energy that can be released over a short time. This property means capacitors have a wide range of applications.
Capacitor-discharge ignition is a type of ignition system commonly found in small engines where the energy released from a capacitor ignites an induction coil that, in turn, fires the spark plug.
To calculate the energy stored in a capacitor of...
Energy In A Magnetic Field01:23

Energy In A Magnetic Field

If a magnetic field is sustained, there must be a current in a closed circuit or loop, implying some energy has been spent in creating the field. If this energy is not dissipated via the circuit's resistance, it is stored in the field.
Take an ideal inductor with zero resistance. Although it's practically impossible, assume that the coil's resistance is so small that it is practically negligible. The loss of the field's energy to dissipate thermal energy (or heat) is thus negligible.
The energy...
Microbial Fuel Cells01:23

Microbial Fuel Cells

Microbial fuel cells (MFCs) are bioelectrochemical devices that generate electricity by exploiting the metabolic processes of electrogenic bacteria. These systems provide a renewable energy source and serve as an innovative method for treating organic waste, such as wastewater.A typical MFC consists of two chambers: an anoxic (oxygen-free) compartment that houses the bacteria and an oxic (oxygen-rich) compartment that contains oxygen as the terminal electron acceptor. Many MFCs use proton...
AC Sources01:20

AC Sources

Direct current is a flow of electric charge in only one direction and has a steady state of constant voltage in the circuit. Rectifiers, batteries, commutator-equipped generators, and fuel cells are some examples of devices that generate direct current. Nowadays, most applications use a time-varying voltage source. Alternating current is a flow of electric charge that periodically reverses direction. An alternating current is produced by an alternating emf that is generated in a power plant. If...
Energy Associated With a Charge Distribution01:21

Energy Associated With a Charge Distribution

The work done to bring a charge through a distance r is given by the potential difference between the initial and the final position. To assemble a collection of point charges, the total work done can be expressed in terms of the product of each pair of charges divided by their separation distance, defined with respect to a suitable origin. Solving this expression gives the energy stored in a point charge distribution.