Related Experiment Video
Updated: Aug 8, 2026

Reducing Willow Wood Fuel Emission by Low Temperature Microwave Assisted Hydrothermal Carbonization
Published on: May 19, 2019
The benefits and costs of reducing emissions from the electricity sector
Karen Palmer1, Dallas Burtraw, Jhih-Shyang Shih
1Resources for the Future, 1616 P Street, NW, Washington, DC 20036, USA. Palmer@RFF.org
Abstract:
Recent federal policy proposals to reduce emissions of sulfur dioxide (SO(2)), nitrogen oxides (NO(x)), and mercury from the US electricity sector promise important improvements in air quality and reductions in acid deposition. The cost of achieving these reductions depends on the form and stringency of the regulation. In this research, we analyze the economic benefits and costs of the US Environmental Protection Agency's (EPA's) Clean Air Interstate Rule (CAIR) as characterized in the supplemental rule proposed in June 2004, and the Clean Air Mercury Rule (CAMR) as proposed in February 2004. The assessment integrates a model of the electricity sector, two models of atmospheric transport of air pollutants, and a model of environmental and public health endpoints affected by pollution. We model explicitly the emissions of SO(2), NO(x), mercury and carbon dioxide (CO(2)) and the effects of changes in emissions of SO(2) and NO(x) on environmental and public health. The manner in which mercury emissions are regulated will have important implications not only for the cost of the regulation, but also for emission levels for SO(2) and NO(x) and where those emissions are located. We find the economic benefits of CAIR and CAMR are far greater than the costs. Recent estimates of benefits of reductions in mercury and acidification indicate that our model captures the lion's share of quantifiable benefits. We also find that the EPA would have been justified on economic grounds in pursuing additional SO(2) emissions reductions beyond the requirements of CAIR.
Related Concept Videos
Electrical Energy
Reducing Line Loss
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...
Power Factor Correction
Energy Losses in Transformers
There are four main reasons for energy losses in transformers.
The first cause can be the high resistance of the copper windings...
Energy Conservation and Bernoulli's Equation
All the terms in the equation have the dimension of energy per unit volume. The kinetic energy per unit volume is called the kinetic energy density, and the potential energy per unit volume is...
Line Loss
Line loss impacts power delivery efficiency in a balanced three-phase circuit. The symmetry in such a circuit simplifies the...