Related Experiment Video

Updated: Aug 8, 2026

Force-Clamp Rheometry for Characterizing Protein-based Hydrogels
09:55

Force-Clamp Rheometry for Characterizing Protein-based Hydrogels

Published on: August 21, 2018

Effects of applied contact force and volume control setting on output force levels of the BAHA Softband

William E Hodgetts1, Susan D Scollie, Ryan Swain

  • 1Department of Speech Pathology and Audiology, University of Alberta, Edmonton, AB, Canada. bill.hodgetts@ualberta.ca

International Journal of Audiology
|May 24, 2006
PubMed

Related Concept Videos

Forced Oscillations01:06

Forced Oscillations

When an oscillator is forced with a periodic driving force, the motion may seem chaotic. The motions of such oscillators are known as transients. After the transients die out, the oscillator reaches a steady state, where the motion is periodic, and the displacement is determined.
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and reloaded.
Power Expended by a Constant Force00:57

Power Expended by a Constant Force

The relationship between work done and the time taken to do it can be explained using the concept of power. For example, several sprinters in a race may have the same velocity when they reach the finish line, therefore doing the same amount of work, but the winner does it in the least amount of time. Thus, power is defined as the rate of doing work. Since work can vary as a function of time, the average power is defined as the work done during a time interval, divided by the time interval.
Effects of feedback01:24

Effects of feedback

Feedback in control systems plays a critical role in shaping various operational parameters, extending beyond simple error reduction to influence stability, bandwidth, gain, impedance, and sensitivity. Understanding these effects requires examining a basic feedback system characterized by defined input, output, error, and feedback signals.
Feedback significantly modifies the gain of a control system. The gain of a system without feedback is altered by a factor of one plus GH, where G represents...
Machines: Problem Solving I01:22

Machines: Problem Solving I

A toggle clamp is a mechanical device commonly used for holding and clamping objects in various applications, such as woodworking, metalworking, and assembly operations. Consider a toggle clamp subjected to a force of 200 N at the handle. The vertical clamping force can be calculated, provided the dimensions of the toggle clamp are known.
The toggle clamp system is a machine structure consisting of movable, pin-connected multi-force members that form a stabilized system to transmit forces. The...
Static and Kinetic Frictional Force01:05

Static and Kinetic Frictional Force

One of the simpler characteristics of sliding friction is that it is parallel to the contact surfaces between systems, and is always in a direction that opposes the motion or attempted motion of the systems relative to each other. If two systems are in contact and moving relative to one another, then the friction between them is called kinetic friction. For example, kinetic friction slows a hockey puck sliding on ice.
However, if two systems are in contact and are stationary relative to one...