Related Experiment Video
Updated: Aug 8, 2026

Spark Plasma Sintering Apparatus Used for the Formation of Strontium Titanate Bicrystals
Published on: February 9, 2017
Thermal dissociation of SO3 at 1000-1400 K
Ayten Yilmaz1, Lusi Hindiyarti, Anker D Jensen
1Department of Chemical Engineering, Technical University of Denmark, DK-2800 Lyngby, Denmark.
Abstract:
The thermal dissociation of SO3 has been studied for the first time in the 1000-1400 K range. The experiments were conducted in a laminar flow reactor at atmospheric pressure, with nitrogen as the bath gas. On the basis of the flow reactor data, a rate constant for SO3 + N2 --> SO2 + O + N2 (R1b) of 5.7 x 10(17) exp(-40000/T) cm3/(mol s) is derived for the temperature range 1273-1348 K. The estimated uncertainty is a factor of 2. The rate constant corresponds to a value of the reverse reaction of k1 approximately 1.8 x 10(15) cm6 mol(-2) s(-1). The reaction is in the fall-off region under the investigated conditions. The temperature and pressure dependence of SO2 + O (+N2) was estimated from the extrapolation of low temperature results for the reaction, together with an estimated broadening parameter and the high-pressure limit determined recently by Naidoo, Goumri, and Marshall (Proc. Combust. Inst. 2005, 30, 1219-1225). The theoretical rate constant is in good agreement with the experimental results. The improved accuracy in k(1) allows a reassessment of the rate constant for SO3 + O --> SO2 + O2 (R2) based on the data of Smith, Tseregounis, and Wang (Int. J. Chem. Kinet. 1982, 14, 679-697), who conducted experiments on a low-pressure CO/O2/Ar flame doped with SO2. At the location in the flame where the net SO3 formation rate is zero, k2 = k1[SO2][M]/[SO3]. A value of 6.9 x 10(10) cm3 mol(-1) s(-1) is obtained for k2 at 1269 K with an uncertainty a factor of 3. A recommended rate constant k2 = 7.8 x 10(11) exp(-3065/T) cm3 mol(-1) s(-1) is consistent with other flame results as well as the present flow reactor data.
Related Concept Videos
Sample Preparation for Analysis: Advanced Techniques
Acid digestion with strong acids is commonly used to dissolve inorganic materials that are insoluble (do not dissolve) in water. This method can be useful for...
Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature from...
Calculating Standard Free Energy Changes
Preparation and Reactions of Thiols
Sublimation
Preparation and Reactions of Sulfides

