Related Experiment Video
Updated: Aug 8, 2026

A New Straightforward Method for Lipophilicity (logP) Measurement using 19F NMR Spectroscopy
Published on: January 30, 2019
Heterogeneous uptake of 8-2 fluorotelomer alcohol on liquid water and 1-octanol droplets
Yongquan Li1, Kenneth L Demerjian, Leah R Williams
1Atmospheric Sciences Research Center, State University of New York, 251 Fuller Road, Albany, New York 12203, USA.
Abstract:
The heterogeneous uptake of the 8-2 fluorotelomer alcohol, F(CF2)8CH2CH2OH, on liquid water surfaces over the temperature range 256-273 K and on 1-octanol surfaces over the temperature range 264-295 K has been investigated with a droplet train flow reactor. The uptake coefficient on water droplets is zero within the error of the measurement (+/-0.01) and is independent of droplet temperature. In contrast, significant uptake onto 1-octanol is observed. Measured uptake coefficients for 1-octanol showed a negative temperature dependence, varying from 0.034 +/- 0.005 (1sigma) at 295 K to 0.103 +/- 0.009 at 264 K. The measured uptake coefficients on 1-octanol were independent of gas-liquid contact time, for typical contact times varying between 3 and 15 ms, and independent of the 8-2 fluorotelomer alcohol gas-phase concentration, indicating that the uptake coefficients are equivalent to mass accommodation coefficients. The uptake coefficients on 1-octanol were also independent of relative humidity. These results show that the uptake of FTOHs on or into the aqueous component of cloud/fog droplets or aqueous aerosol particles is not likely to be an important atmospheric sink for these compounds. In these experiments, 1-octanol was used as a model compound for organic-containing atmospheric particles. The larger uptake coefficient measured for 1-octanol surfaces indicates that FTOH partitioning to organic-containing cloud/fog droplets and aerosol particles may be an atmospheric loss mechanism.
Related Concept Videos
Physical Properties of Alcohols and Phenols
Alcohols possess a higher boiling point than aliphatic hydrocarbons of similar...
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Preparation of Alcohols via Addition Reactions
The acid-catalyzed addition of water to the double bond of alkenes is a large-scale industrial method used to synthesize low-molecular-weight alcohols. An acidic atmosphere is required to allow the hydrogen in the water molecule to act as an electrophile and attack the double bond in an alkene. The addition of a proton to the double bond creates a carbocation intermediate. The proton preferentially bonds to the less substituted end of the double bond to create a more stable carbocation...
Regioselectivity and Stereochemistry of Acid-Catalyzed Hydration
Entropy and Solvation
Formation of Halohydrin from Alkenes

