Related Experiment Video
Updated: Aug 5, 2026

Electroactive Polymer Nanoparticles Exhibiting Photothermal Properties
Published on: January 8, 2016
Solubilization of polyelectrolytic hairy-rod polyfluorene in aqueous solutions of nonionic surfactant
Matti Knaapila1, Laszló Almásy, Vasil M Garamus
1Department of Physics, University of Durham, South Road, Durham DH1 3LE, United Kingdom. matti.knaapila@durham.ac.uk
Abstract:
We report on the solubilization, phase behavior, and self-organized colloidal structure of a ternary water-polyfluorene-surfactant (amphiphile) system comprised of polyelectrolytic poly{1,4-phenylene[9,9-bis(4-phenoxybutylsulfonate)]fluorene-2,7-diyl} (PBS-PFP) in nonionic pentaethylene glycol monododecyl ether (C12E5) at 20 degrees C. We show in particular how a high amount (milligrams per milliliter) of polyfluorene can be solubilized by aqueous C12E5 via aggregate formation. The PBS-PFP and C12E5 concentrations of 0.31 x 10(-4)-5 x 10(-4) M and 2.5 x 10(-4)-75 x 10(-4) M, respectively, were used. Under the studied conditions, the photoluminescence (PL), surface tension, static contact angle, and (pi-A) isotherm measurements imply that D2O-PBS-PFP(C12E5)x realizes three phase regimes with an increasing molar ratio of surfactant over monomer unit (x). First, for x < or = 0.5, the mixture is cloudy. In this regime polymer is only partially dissolved. Second, for 1 < or = x < or = 2, the solution is homogeneous. In this regime polymer is dissolved down to the colloidal level. Small-angle neutron scattering (SANS) patterns indicate rigid elongated (polymer-surfactant) aggregates with a diameter of 30 A and mean length of approximately 900 A. The ratio between contour length and persistence length is less than 3. Third, for x > or = 4, the solution is homogeneous and there is cooperative binding between polymer and surfactant. Surface tension, contact angle, and surface pressure remain essentially constant with increasing x. A PL spectrum characteristic of single separated polyfluorene molecules is observed. SANS curves show an interference maximum at q approximately 0.015 A(-1), indicating an ordered phase. This ordering is suggested to be due to the electrostatic repulsion between polymer molecules adsorbed on or incorporated into the C12E5 aggregates (micelles). On dilution the distance between micelles increases via 3-dimensional packing. In this regime the polymer is potentially dissolved down to the molecular level. We show further that the aggregates (x = 2) form a floating layer at the air-water interface and can be transferred onto hydrophilic substrates.
More Related Videos
07:01Preparation of Hollow Polystyrene Particles and Microcapsules by Radical Polymerization of Janus Droplets Consisting of Hydrocarbon and Fluorocarbon Oils
Published on: January 25, 2018
06:31Studying Surfactant Effects on Hydrate Crystallization at Oil-Water Interfaces Using a Low-Cost Integrated Modular Peltier Device
Published on: March 18, 2020
Related Concept Videos
Molecular Shape and Polarity
Colloids
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules, atoms, and/or ions)...
Entropy and Solvation
Surface Active Agents
Micelles