Surface modification of polystyrene using polyaniline nanostructures for biomolecule adhesion in radioimmunoassays

The selection of an appropriate surface as a solid phase for coupling antibodies is a critical step in the development of solid-phase immunoassays. Availability of a new method of preactivating the surface of polystyrene tubes with a layer of another polymer for enhanced immobilization of antibodies seems to be promising. In this paper, we report the activation of a polystyrene surface using a layer of polyaniline and its effect on immobilizing antibodies for use as a solid phase in a T3 immunoassay. The modified surface on the polystyrene was characterized by optical absorption, X-ray photoelectron spectroscopy (XPS), and atomic force microscopy (AFM). The modified tubes were coated with antibody and evaluated for their performance in the assay and validated for radioimmunoassay of T3. AFM images of the modified surface showed an enhancement in the surface roughness (Ra of 20.2 nm), as compared to an unmodified surface (Ra of 6 nm), allowing more adsorption of antibodies to the surface. XPS revealed the presence of N (binding energy approximately 400 eV) on the modified surface, which could help the antibody molecules to bind to these preactivated (modified) tubes. The modified tubes, when coated with antibody, not only showed an increase in the binding with the radioiodinated tracer but also improved the precision of coating the antibody. The present method of activating polystyrene surfaces is simple, does not involve severe chemical treatment, and may have wide applicability to functionalize other supports for immobilizing biomolecules.