New ORP/pH based control strategy for chlorination and dechlorination of wastewater: pilot scale application

Due to its efficiency and low capital demands, chlorination has been widely used for disinfection in many wastewater treatment plants. Since the oxidation power of free chlorine is bigger than combined chlorines which are formed from the reaction between chlorine and reducing agents in water (especially, NH4+ and organic nitrogen), for effective disinfection, excess amount of chlorine is added until all the reducing agents are oxidized and free chlorine is available. After chlorination, chlorine residues in wastewater are usually reduced with SO2 or sulfites before the treated wastewater is discharged, since they are toxic to aquatic life. Addition of excess amount of SO2 or sulfite should be avoided. Otherwise, they consume dissolved oxygen in a river or stream and may have adverse impact on the aquatic life. Determination of wastewater chlorine demand and of sulfite dosages for dechlorination has been a challenge to WWTP operators, due to the dynamic characteristics of wastewater. Recently, a new ORP/pH based approach to determine chlorine demand and sulfite dosage was proposed. The method utilizes significant points occurring on the pH and ORP profiles during chlorination and dechlorination titrations. In this study, the proposed automatic titration system has been implemented into a control system to optimize chlorine and sulfite doses for a pilot scale chlorination/dechlorination system. In short, the disinfection system with the pH/ORP based controller showed very successful results; complete inactivation of total coliforms, and almost zero residual chlorines and high DO in its effluent.