Universal mean moment rate profiles of earthquake ruptures

Amit P Mehta1, Karin A Dahmen, Yehuda Ben-Zion

  • 1Department of Physics, University of Illinois at Urbana-Champaign, 61801-3080, USA. mehtafree@yahoo.com

Related Concept Videos

Moment-Area Theorems01:17

Moment-Area Theorems

The Moment-Area Theorem is crucial in structural engineering for analyzing beam bending, particularly in applications like building floor supports. This theorem utilizes the geometric properties of the elastic curve, which depicts how a beam deforms under load, to simplify the calculations of deflections and slopes.
The theorem is divided into two parts. The first part connects the angle between tangents at any two points on the beam's elastic curve to the area under a curve derived by plotting...
Modes of Standing Waves - I01:03

Modes of Standing Waves - I

A close look at earthquakes provides evidence for the conditions appropriate for resonance, standing waves, and constructive and destructive interference. A building may vibrate for several seconds with a driving frequency matching the building's natural frequency of vibration; this produces a resonance that results in one building collapsing while the neighboring buildings do not. Often, buildings of a certain height are devastated, while other taller buildings remain intact. This phenomenon...
Dynamic Modulus of Elasticity of Concrete01:16

Dynamic Modulus of Elasticity of Concrete

The dynamic modulus of elasticity assesses how a concrete structure deforms under impact or dynamic loads. It is typically higher than the static modulus of elasticity, measured under slow, steady loading conditions.
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...
Elastic Strain Energy for Shearing Stresses01:20

Elastic Strain Energy for Shearing Stresses

As discussed in previous lessons, strain energy in a material is the energy stored when it is elastically deformed, a concept crucial in materials science and mechanical engineering. This energy results from the internal work done against the cohesive forces within the material. When a material undergoes shearing stress and corresponding shearing strain, the strain energy density, which is the energy stored per unit volume, is calculated. Within the elastic limit, where the stress is...
Elastic Strain Energy for Normal Stresses01:22

Elastic Strain Energy for Normal Stresses

Strain energy quantifies the energy stored within a material due to deformation under loading conditions, a fundamental concept in materials science and engineering. The strain energy can be modeled when a material is subjected to axial loading with uniformly distributed stress. In this scenario, the stress experienced by the material is the internal force divided by the cross-sectional area, and the strain induced is directly proportional to this stress through the modulus of elasticity.
If...
Principle of Moments01:20

Principle of Moments

The principle of moments, also known as Varignon's theorem, is a fundamental concept in physics and engineering that describes the equilibrium of a rigid body under the influence of external forces. The principle states that the moment of a force about a point is equal to the sum of the moments of the components of the force about the same point.
The moment is calculated by multiplying the magnitude of the force by the perpendicular distance from the point of application to the point about...